- Clarion / Pioneer / Jensen / Dual marine mode bypass using TR7 -
Pacific Accessory Corporation
Black (-) Chassis Ground
Green (+) 0.8-16 Volts Input Trigger
Red (+) 12 volts constant/switched
Brown (-) Input Trigger
Blue (+) 12 volt output-2 amps max
White (-) Output-150 ma. max
Orange (-) Output-150 ma. max
MODEL TR7
Universal Trigger Output Module
OFF-ON
Programming switch must be turned off
after the PTR7 is programmed!
87
30
87a
86 85
Parking Brake
wire from radio
12v
Switched
Remote wire
from radio
1. Start with ONLY power and ground connected. Turn the programming switch on
TR-7 to the ON position.
2. Turn power on and then pulse brown wire to ground 17 times. (after 3 seconds the
LED will flash back to you 17 times)
3. Pulse the brown wire to ground one time to start the timer programming.
a. The LED will rapidly flash once. You will do nothing.
b. The LED will then rapidly flash twice. You will pulse the brown wire to ground
once. After three seconds the LED should flash one time to confirm that it
accepted it.
c. The LED will rapidly flash three times. You will do nothing.
d. The LED will rapidly flash four times. You will do nothing.
4. The LED will rapidly flash a bunch of times and then go out.
5. Turn the power off and move the programming switch on the TR-7 to the off position.
6. Connect the TR-7 according to the diagram below.
*Marine Mode is for use in water vessel’s only. In no way is it intended for use while operating any vehicle on-road.*
*Marine Mode is for use in water vessel’s only. In no way is it intended for use while operating any vehicle on-road. *
Standard (SPDT)
30amp Relay
J1850
Class 2
VPW
Class 2
J1850
100011101111001001 101 100
1110100001 101 10111001 100
Arbitration
EOD
CRC
100011101111001001 101 100
1110100001 101 10111001 100
Class 2
Class 2
J1850
Pacific Accessory Corporation - 1340 Ritchey Street, Santa Ana, CA. 92705
[email protected] • www.pac-audio.com
2-23-2010 TT
ver. 2
/
