2
KORG Pa500 – Operating System release 1.10
Style Play Mode
SC Preset buttons
Press these buttons to recall the corresponding presets. Each pre-
set contains a custom detuning of each note of the scale (shown
in the upper scale diagram). It also memorizes the selected
degree(s) of the scale (shown in the lower scale diagram).
When no preset is selected, the default scale is automatically
recalled. This scale assigns a -50 cent value to all notes, and turns
all scale degrees off.
You can select an SC Preset, also by assigning the relevant func-
tion to the Assignable Switch or Assignable Footswitch.
When one of the SC Preset buttons on the control panel is kept
pressed for more than one second, the current scale program-
ming is saved to the corresponding preset. A confirmation mes-
sage will appear for some seconds in the display. (Only available
on some models).
As an alternative, while in the Global > General Controls > Scale
page, choose the “Write SC Preset” command from the page
menu, and select one of the preset locations where to save the
current settings.
Upper scale diagram
Use this diagram to set the detuning of each note of the scale.
-99…0…+99 Note detuning in cents. Zero is no detuning, ±50
is a full quarter tone up or down, ±99 is nearly
one whole semitone up or down.
Lower scale diagram
Use this scale to turn detuning on or off. Applied detuning will
depend on the programming set with the Upper scale diagram,
or recalled by selecting one of the SC Presets.
When a note is detuned, a black dot appears in the correspond-
ing note of the diagram. An LED turns on over the correspond-
ing key of the Quarter Tone SubScale Keypad in the control
panel.
Quarter Tone SubScale shortcut
Keep the SHIFT button pressed, and press one of the Quarter
Tone SubScale Keypad buttons to open the Global > General
Controls > Scale page. (Only available on some models).
Quarter Tone SubScale assignable functions
Five new functions can be assigned to the Assignable Switch
(Style Play > Pad/Switch > Assignable Switch page) and Assign-
able Footswitch (Global > Controllers > Pedal/Switch/Slider
page).
Style Play Mode
Local Pad banks
One more type of Pad banks has been added: the Local bank.
These banks may contain Pads customized for the local market.
When choosing the Local type in the Pad Select window, four
side tabs appear, each one containing four pages.
Pad Record Mode
Local Pad banks for saving Pads
After editing or recording, Pads could be saved to the Local type
of banks, in addition to the already existing ones.
Note: To save Pads to these banks, the Media > Preferences > Fac-
tory Style and Pad Protect option must be turned off.
Sequencer Mode
Recording Quarter Tone settings or SC Pre-
sets into a Song
Access the Sequencer mode and go to the Mixer/Tuning > Sub
Scale page. Check each track you want to apply the sub scale, by
using the Track Assign checkboxes.
Press RECORD and enter 16-track recording mode. No Quarter
Tone selection is done, nor SC Preset is selected, and any change
to the default sub scale settings is deleted.
Start recording. Immediately after having started the sequencer,
choose one of the SC Presets (or press one of the SC Preset but-
tons on the control panel – only available on some models). The
selection is recorded to the Song.
If you are recording a Backing Sequence, using Quarter Tone or
SC Presets is the same as in Style Play mode. No need to assign
the sub scale to the various tracks before accessing the Record
mode.
Function Meaning
Global-Scale When the switch or footswitch is
pressed, the Global > General Controls >
Scale is recalled in the display.
SubScale Preset 1
(SC1)…4 (SC4)
Same functions of the SC Preset buttons
in the control panel.
Pa500-110U-EFGI.book Page 2 Thursday, January 10, 2008 12:11 PM