5
(800) 379-2340
For customer and technical support
Step 4– Plug the small end of the power cable into the
back of the TickBox, and connect the other end to your
nearest wall outlet, or power strip.
Step 5- Point the hand held remote at the front of the
TickBox, and then press the RED power button. You
should then see a BLUE light illuminate on the front of
the TickBox, this indicates the box is now on.
* Another important thing to remember is that when us-
ing the handheld remote, you will need to point the re-
mote towards the blue light on the TickBox, otherwise
the action will not be recognized*
Step 6– Select the corresponding input on your TV. You
will need to know which HDMI port you plugged the
HDMI cable into for this.
Once you have the input properly selected you will see
the welcome screen. Now it is time to setup the box
Continued on page 6
6
Initial Setup
TickBox TV will prepare itself
for the rst run. Please be
patient, this takes a few mo-
ments.
Once you select “Start” you
will be prompted to connect
to a wi network, if you are
not already connected via
Ethernet cable. Only required
on rst run, or after a factory
reset.
Choose your Wi-Fi network,
and input your Wi-Fi pass-
word (Must be at least 8
characters). Then select the
green arrow shown towards
the right of the keyboard.
Follow the prompts to install
the media player. Install, then
done. Select install again, on
next page, and then on the
following page select launch.