red lion MobilityPro BT?5800 Series Quick start guide

QUICKSTARTGUIDE

MobilityPro

BT‐5800Series

WirelessModem

OVERVIEW

TheMobilityProTMBT‐5800modemsarerugged3Gwirelessmodems

builttoprovidesimpleandreliablecommunicationovertheHSDPA/

HSUPAorEDGEcellulardatanetwork.

Thisguidecover sinitialconfigurationfortheBT‐5800&BT ‐5830.

FEATURES

• HSDPA/HSUPAwithfallbacktoEDGE/GPRS

• Diversityantenna

• Ethernet,Serial,USBandWiFi(5830modelonly)

• ReliableAlways‐oncellularlink

• Ruggedindustrialdesign

• Remotediagnostics,configurationandupdates

• 3Analoginputs,4digitalinputs,3digitaloutputs

• IPSecVPNmultipletunneland3DES|AESupto256‐bitencryption

LEDINDICATORS

ADDITIONALINFORMATION

Visitoursupportpageatwww.redlion.nettoaccesstheModemUser’s

Guideforanin‐depthoverviewofthemodem’sfeaturesandcapabili‐

ties,aswellasconfigurat ionhelpandtroubleshooting.ContactTechni‐

calSupportat1‐877‐432‐9908orsupport@redlion.net.

POWER

Themodemhasa4‐pinMolexconnectorforpowerinputandrequires

apowersourcebetween8and30VDC.

ANTENNA

AnantennawithanSMAconnectorshouldbeconnectedtothe

modem.Thisantennashouldmeetthefollowingspecifications:

• Dual‐band800&1900MHz

• Nominal50ohmimpedance

• VoltageStandingWaveRadio(VSWR)lessthan2.5:1

*Antennasaresoldseparately.

DATAINTERFACES

Ethernet:10/100MbpsAuto‐sensingFemaleRJ45port

USB:USB2.0TypeBFemale

Serial:RS‐2329pinDCEFemale,withthesedefaultsettings:

• Speed:115200bps

• Databits:8

• Parity:None

• StopBits:1

• FlowControl:Hardware

SETUP

1. Setupadataaccountforthemodem

Contactyourcellularprovider(carrier)andrequestadataaccount.The

carriershouldprovideyouwithaSIMcardtoinsertintothemodem,

alongwiththeAPN/usrename/passwordfordataconnectivity.

2. InserttheSIMcard

1. LocatetheSIMslotontherightsideofthe

unit.

2. Insertthecardwithitscutsidefacingforwardandontheleft.

3. Usingthetipofapen,pushitinuntilitclicks.

LED State Description

Power ON Powerisappliedtotherouter

Signal

ON Excellentsignalstrength

FLASH Flashesfasterassignalisstonger

OFF Veryweakornosignal(lessthan‐100dBm)

WAN

ON Wirelesslinkestablished,butnodataactivity

FLASH Datatransmitted/receivedonwirelessnetwork

RS232

ON Linkestablishedwithserialdevicebutnodata

activity

FLASH Datatransmitted/receivedwithattachedserial

device

GPS

ON Positionfix

available

OFF Nopositionfixavailable

Ethernet

Link

ON LinkestablishedwithEthernetdevice

Ethernet

Activity

FLASH Datatransmitted/receivedwithattached

Ethernetdevice

LABEL DESCRIPTION

GND Ground

POS Power8to30VDC(12or24VDCnominal)

IGN Ignitionsense

O3 Digitaloutput

Quick Start Guide

3. Wiringandpower‐up

1. ConnectthemodemtoyourcomputerusingastandardEthernet

cable.Alternatively,theRS‐232orUSBportscanbeusedfor

setup.

2. ConnectthecellularantennatotheAntennaconnector.

3. Pluginthepowerconnectortopower‐upthemodem.

4. StartBlueVueDeviceManagerSoftware

1. Download

andinstallthelates tversionofBlueVueDeviceMan‐

agerfromwww.redlion.net.

2. Whenlaunched,itwillattempttoconnectto192.168.0.1by

default,onceconnectedtothemodem,theModemDiagnostic

windowwillopen.Notethat192.168.0.1connectstotheEthernet

cable.ToconnecttotheUSBportuse192.168.111.1):

Troubleshooting:IfBlueVuedisplays“DetectingModemat

192.168.0.1”indefinitely,then:

• Makesurethemodemispoweredon.

• ChecktheEthernetLinkLEDonthemodem.Ifit’soff,itusually

meansyouhaveaproblemwiththeEthernetcableorwithyour

computer’snetworkcard.

• Closeallothernetworkconnections(suchas

WiFi)

• SetyourcomputertoobtainanIPaddressautomatically

5. Confirmthatthemodemisacquiringacellularsignal

TheSignalLEDshouldbeonorflashing,indicatingthatthemodemhas

asignal.BlueVueDeviceManagerdisplayssignalinformationinthetop

rightofitswindow;aminimumof1

barisrequiredtoconnecttothe

carrierwiththemodem.

Troubleshooting:IftheSignalLEDisoff,thentheremaybeanissue

withtheantennaorcelluarcoveragemightbetoolowinyourcurrent

location.

6. SettheWANdataconnection

1. InBlueVueDeviceManager,clickontheWANbutton.

2. Settheusernameandpasswordifprovidedbythecarrier.

3. SettheAPNasprovidedbythecarrier.

4. Clicksubmit.

5. Confirmthemodemhassuccessfullyconnectedtothecellu‐

larnetwork:

• TheWANLEDwillbeonorflashing

• InBlueVue,clicktheDIAGbutton,theWANIPshoudl

indicatetheIPaddressassignedtothemodembythe

cellular

network.

SETUPISCOMPLETE

Themodemshouldbereadyforuseasabasicinternetaccesspoint.For

moreadvancedmodemconfiguration,consultthesupportsectionon

ourwebsite:www.redlion.net

INSTALLATIONANDHAZARDOUSAREAWARNINGS

SuitableforuseinClassI,Division2,GroupsA,B,CandDhazardous

locations,ornon‐hazardouslocationsonly.Allpower,inputandoutput

(I/O)wiringmustbeinaccordancewithClassI,Division2wiringmeth‐

odsandinaccordancewiththeauthorityhavingjurisdiction.

WARNING‐EXPLOSIONHAZARD‐

DONOTDISCONNECTEQUIPMENT

UNLESSPOWERHASBEENSWITCHEDOFFORTHEAREAISKNOWNTO

BENON‐HAZARDOUS.

WARNING‐EXPLOSION HAZARD‐SUBSTITUTION OF COMPONENTS

MAYIMPAIRSUITABILITYFORCLASSI,DIVISION2.

WARNING‐EXPLOSION HAZARD‐BATTERIES MUST ONLY BE

CHANGEDINANAREAKNOWNTOBENON‐HAZARDOUS.

WARNING‐EXPOSURETOSOMECHEMICALSMAYDEGRADETHESEAL‐

INGPROPERTIESOFMATERIALSUSEDINTHERELAYS.

AVERTISSEMENTSPOURINSTALLATIONET

ENDROITSDANGEREUX

CetéquipementestadaptépouruneutilisationenClasseI,Division2,

GroupesA,B,CetDpourendroitsdangereux,ouendroitsnon‐dan‐

gereuxseulement.Toutcâblageélectrique,entréeetsortie(I/O)doi‐

ventêtreenconformitéavecClasseI,Division2méthodesdecâblage

conformémentàl'autoritécompétente.

AVERTISSEMENT‐RISQUE D'AVERTISSEMENT‐NE DÉBRANCHEZ PAS

L'ÉQUIPEMENT PENDANT QUE LE CIRCUIT EST DIRECT OU À MOINS

QUEL'ENVIRONNEMENTSOITCONNUPOURÊTRENON‐DANGEREUX.

AVERTISSEMENT‐RISQUED'EXPLOSION‐LASUBSTITUTIONDETOUT

COMPOSANTPEUTNUIREÀLACONFORMITÉDECLASSEI,DIVISION2.

AVERTISSEMENT‐RISQUE D'EXPLOSION‐ LES BATTERIES DOIVENT

SEULEMENT ÊTRE REMPLACÉES DANS UNE ZONE RECONNUECOMME

ÉTANTNON‐DANGEREUSE.

AVERTISSEMENT‐L'EXPOSITION À CERTAINS PRODUITS CHIMIQUES

PEUTDÉGRADERLESPROPRIÉTÉSD'ÉTANCHÉITÉDESMATÉRIAUXUTIL‐

ISÉSDANSLESRELAISÉTANCHEPÉRIPHÉRIQUE.

red lion MobilityPro BT?5800 Series Quick start guide

Related papers

Other documents