It's Exciting Lighting IEL-7001 Installation guide

Hello! I am your chat assistant, and I have analyzed the user manual for the Flameless Candle Battery Powered Sconce. This manual provides detailed instructions for setup, including battery installation, wall mounting, and operation of the device with its automatic timer mode. I am ready to answer any questions you may have about this product.
What type of batteries does the sconce use?

How long will the batteries last in 'on' mode?

How long will the batteries last in 'flicker' mode?

Can I use the product outdoors?

How long does the light operate in automatic mode?

Flameless Candle Battery

Powered Sconce

Steps

1. Place glass shade 5 into base 6 as shown (Figure 1). Place retaining nut 4 over candle thread in the center and tighten.

2. Insert 3 pcs C size Alkaline batteries (Figure 2). IMPORTANT: pay careful attention to the polarity of the batteries and

ensure they are inserted in the correct direction as shown on the battery cover illustration. Failure to install batteries in the

correct direction may cause damage to the product.

3. Determine where the product is to be mounted and pre-drill for the wall anchors 1 . Insert wall anchors 1 into wall. (Omit if

screwing directly into a wall stud). Hold mounting bracket 3 . (Figure 3).

4. Align mounting slots on back of lighting unit 6 with the 2 mounting clips 3 on wall mounting bracket 3 . Fasten onto wall.

5. Insert the lighting unit onto wall mounting bracket 3 as shown (Figure 4).

6. Slide switch to “on” or “flicker” mode. The lighting unit 6 will operate for 4 hours once activated, then off for 20 hours

then repeat the cycle at the same time everyday (unless manually switched to “off” mode).

7. Batteries will last up to 100 days in “on” mode and up to 125 days on “flicker” mode based on daily use

Safety

1. This product is intended for indoor use only. Please keep away from moisture.

2. Do not disassemble the unit.

3. Do not mix batteries. To prevent equipment damage, and possible injury, never mix batteries with different chemistries or

voltages in the equipment at the same time. Remove batteries from unit for long time storage to prevent damage from

battery leakage. IMPORTANT: pay careful attention to the polarity of the batteries and ensure they are inserted in the

correct direction as shown on the battery cover illustration. Failure to install batteries in the correct direction may cause

damage to the product.

Customer Service

For immediate answers visit our website www,smartlivinghg.com where you will find troubleshooting and FAQs or contact us

using the details below. One year manufacturer’s warranty.

If no stud, drill

and insert wall anchors

If stud is available, drill

screws directly into it

Telephone: + 1 813 343 5775

Web: www.itsexcitinglighting.com