Seastar Solutions HA5477 Installation guide

Seastar Solutions
Brand
Seastar Solutions
Model
HA5477
Category
Engine
Type
Installation guide
OUTBOARD CYLINDER
GROUNDING STRAP
Part # HA5477
Crimping Details
The Grounding Strap Kit is designed to provide added protection
against corrosion caused by stray current. This is designed for
use on SeaStar and BayStar front mounting outboard cylinders.
1. Using figures A, B & C determine your style of steering cylinder.
2. Measuring from the large hole, crimp terminal as per the length
noted next to your cylinder style. Crimp terminal to ground strap
using pliers.
7.25"
CRIMP/FOLD UP TO SECURE TO GROUND STRAP SMALL HOLELARGE HOLE
SeaStar Slide Cylinders
5.25"
CRIMP/FOLD UP TO SECURE TO GROUND STRAP SMALL HOLELARGE HOLE
SeaStar Pivot & Tournament
Cylinders
SMALL HOLE
NOT USED
LARGE HOLE
BayStar Cylinders
A
B
C
INSTALLATION INSTRUCTIONS
Copy Part# 296800, Rev. C, 12/2014 Page 1 of 2
© 2007 Marine Canada Acquisition Inc. DBA SEASTAR SOLUTIONS 3831 No. 6 Road, Richmond, B.C. Canada V6V 1P6 Fax: 604.270.7172 Web: www.seastarsolutions.com
1. Install ground strap to cylinder as per figures D and E.
2. Reinstall cylinder and support rod nuts, torque to the following
i Cylinder shaft nut = 33 ft-lbs.
ii Support rod shaft nut = 45 ft-lbs.
3. Attach loose end of ground strap to a good, clean and tight
ground location on the engine power head or mid-section.
4. Ensure there is enough slack in the strap to allow the engine
to pivot freely in ALL trim/tilt positions, throughout the entire
steering range of the engine.
5. SeaStar Solutions recommends the ground strap is secured
using zap straps to prevent a tripping or hang-up hazard.
There MUST be enough slack to allow full steering articulation
in all trim/tilt positions.
GROUND STRAP
RE-USE THIS
WASHER
CYLINDER
SHAFT NUT
SUPPORT
ROD NUT
DISCARD THIS
WASHER
CRIMP TERMINAL
LARGE FIXED
TERMINAL
ATTACH SMALL FIXED
TERMINAL TO SUITABLE
GROUND LOCATION ON
ENGINE POWER HEAD
OR MID-SECTION
Figure D. SeaStar Pivot and Slide Cylinders, Configurations A and B.
Installation Procedure
NOTICE
GROUND STRAP
DISCARD THIS
WASHER
CYLINDER
SHAFT NUT
LARGE FIXED
TERMINAL
ATTACH SMALL FIXED
TERMINAL
TO SUITABLE GROUND LOCATION
ON ENGINE POWER HEAD OR
MID-SECTION
Figure E. BayStar Cylinders, Configuration C.
Cylinder does NOT need to be
removed from engine to perform
the following steps.
INSTALLATION INSTRUCTIONS
Copy Part# 296800, Rev. C, 12/2014 Page 2 of 2
© 2007 Marine Canada Acquisition Inc. DBA SEASTAR SOLUTIONS 3831 No. 6 Road, Richmond, B.C. Canada V6V 1P6 Fax: 604.270.7172 Web: www.seastarsolutions.com
  • Page 1 1
  • Page 2 2

Seastar Solutions HA5477 Installation guide

Seastar Solutions
Brand
Seastar Solutions
Model
HA5477
Category
Engine
Type
Installation guide
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents