Edsal ZB1500 Assembly Manual

Brand: Edsal

Model: ZB1500

Type: Assembly Manual

Instructions : ZB1500

Bulk Storage Rack

General Instructions

2 - Welded End Frames

6 - Beams

3 - Particle Board Shelves

Parts

Safety Instructions

Work Force Bulk Storage Rack is engineered to offer maximum flexibility as well as ease and quickness of assembly.

The rack units can stand individually, or for greater stability, be joined together using the common post. Individual

beams can be adjusted without disturbing the beams in adjoining units. These instructions should be followed exactly.

All parts supplied must be used as shown. Any alteration or deviation from this instruction sheet can result in unit fail-

ure. After the unit is assembled, it must be placed on a level surface for safety, and optimal product performance.

This storage rack unit must be placed on a level surface. Failure to do so can result in unit failure, poor product per-

formance, or a possible “tipping” safety hazard. DO NOT STAND ON THE UNIT OR USE THE UNIT AS A LADDER !

DO NOT OVERLOAD ! Evenly distribute the weight on each shelf, and keep the heaviest loads on the bottom shelf.

Use care and the proper attire when working with metal parts.

Assembly Instructions

Attach the beams to the welded end frames as seen in

figure 1. Use both welded end frames to establish the

left and the right sides of the units. After a beam has

been placed to the end units, tap down with a hammer

to help drive the beam end clip tabs into the end frame

post slots to secure the beam to the end frame (see

figure 1). Note: If the beam end clip tabs become

bent due to mishandling. It may be necessary to

adjust the tabs back to their proper form.

The completed unit should have three (3) levels evenly

spaced for maximum stability. Note: Although the

beams are adjustable in height, it’s recommended to

evenly space them so that the stability of the unit is not

compromised.

After all beams are in place, place the particle board

shelving to each level to complete the unit

(see figure 2).

Particle Board Shelf

Beam

Beam End

Clip Tabs

Figure 1

Figure 2

End Frame Post Slots

End Frame Post

Should you have any comments, damage, missing parts, or problems with assembly of this unit please feel

free to contact our Work Force manufacturing facility at, (773) 475-3000 and request customer service.

To obtain replacement parts, please provide the following information :

- Model # - Part # & Description - Location Purchased - Date Purchased

Consumer Products Division

Edsal Manufacturing Company

4400 South Packers Avenue

Chicago, IL 60609

www.edsal.com

Edsal ZB1500 Assembly Manual

Edsal ZB1500 Assembly Manual

Edsal ZB1500 Assembly Manual

Related papers

Other documents