Gibraltar Building Products LPDH18 Operating instructions

Gibraltar Building Products
Brand
Gibraltar Building Products
Model
LPDH18
Type
Operating instructions

This manual is also suitable for

WIDTH
FRONT
FLANGEFLANGE
HEIGHT
ROOF OPENING
LENGTH
SIDE
HEIGHT
FLANGE
FLANGE
ROOF OPENING
TOP
Nominal Size Rough Opening
9 x 18 12 in. x 9 in.
14 x 12 14 in. x 14 in.
12 x 24 12 in. x 9 in.
1. Make a template of the Rough Opening. Center the
template between rafters on the rear slope of the house.
4. Finish installation by sealing all seams,nails and loose
edges of shingles with roofing cement.
3. Center the throat of the vent over the roof opening.
Fasten with 7 galvanized roofing nails.
Note: Hem may be hammered flat by installer.
2. Drill a starter hole, then saw out the Rough Opening.
Note: Install all exhaust vents at the same height on a roof plane. Installation of
exhaust vents at more than one level allows the upper exhaust vent to pull air in
from lower exhaust vent instead of the soffit intake vents.
In order to maximize exhaust air flow, it is recommended to install the dormer
vents high on the roof plane, within 3 to 4 feet of the ridge.
CAUTION! Working above grade is inherently dangerous, be sure that proper fall protection measures
are in place. When working with power tools, gloves and eye protection are absolutely required.
These installation guidelines are for use with typical or standard applications. It is always recommended to seek advice from a licensed professional,
and to check with your local building inspector or building permit office for approvals and possible variations that may apply.
DORMER VENT
INSTALLATION GUIDELINES
#BH24 #LPDG19
#LPDH18 #LPSD20
#STDS24-2B
  • Page 1 1

Gibraltar Building Products LPDH18 Operating instructions

Gibraltar Building Products
Brand
Gibraltar Building Products
Model
LPDH18
Type
Operating instructions
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents