PYLE Audio AT-3040 is an auto-stop car cassette player with AM/FM 2 band LCD display tuning radio. It features a theft deterrent detachable system for added security. The unit comes with a remote control for convenient operation. Other features include:
- Power supply: DC 12Volts. Negative Ground.
- Unit Dimensions: 178[W]X150[D]X50[H] mm.
- FM Frequency Range: 88MHz - 108MHz.
- AM Frequency Range: 530KHz - 1700KHz.
- LCD display for easy viewing.
- MO/ST button for changing between mono or stereo sound effect.
- Local/Distance Reception Button for improving reception in different locations.
- Clock display and setting buttons.
PYLE Audio AT-3040 is an auto-stop car cassette player with AM/FM 2 band LCD display tuning radio. It features a theft deterrent detachable system for added security. The unit comes with a remote control for convenient operation. Other features include:
- Power supply: DC 12Volts. Negative Ground.
- Unit Dimensions: 178[W]X150[D]X50[H] mm.
- FM Frequency Range: 88MHz - 108MHz.
- AM Frequency Range: 530KHz - 1700KHz.
- LCD display for easy viewing.
- MO/ST button for changing between mono or stereo sound effect.
- Local/Distance Reception Button for improving reception in different locations.
- Clock display and setting buttons.
THEFT DETERRENT DETACHABLE SYSTEM
AUTO-STOP CAR CASSETTE PLAYER
AM/FM 2 BAND LCD DISPLAY TUNING RADIO
PRECAUTIONS
1. Choose the mounting location carefully so that the unit will not interfere with the
normal driving functions of the driver.
2. Avoid installing the unit where it would be subject to high temperatures, such as
from direct sunlight or hot air from the heater, or where it would be subject to
damp, dust, dirt or excessive vibration.
3. Use only the supplied mounting hardware for a safe and secure installation.
INSTALLATION
SPECIFICATION
GENERAL
Power Supply Requirements DC 12Volts. Negative Ground.
Unit Dimensions 178[W]X150[D]X50[H] mm.
FM SECTION
Frequency Range 88MHz - 108MHz.
AM SECTION
Frequency Range 530KHz - 1700KHz.
KEY PLATE
DASH BOARD
PLAIN WASHER
SPRING WASHER
TAPPING SCREW
HEX NUT
HEX BOLT
SLIDE BRACKET HOUSING
METAL MOUNTING STRAP
CONSOLE
To remove the player from the Cage, insert the supplied key
into the slot of the chassis then pull the chassis out of the
cage as shown.
INSTRUCTION MANUAL
AT-3040
www.pyleaudio.com
TONE
H
LOC
M
F/C
VOL
BD
ST
BAL
PWR
CD IN
REL
TUNE
AUTO STOP
MHzFM
LOCATION AND FUNCTION OF CONTROLS
WIRING DIAGRAM
1. POWER ON/OFF BUTTON
Press this button to turn the power supply on or off.
2. VOLUME CONTROL
Slide this control up or down to increase or decrease the volume level.
3. CASSETTE TAPE DOOR
In RADIO mode, insert a cassette into this slot, the tape playback starts automatically.
4. EJECT KEY
In TAPE mode, push this key half way to fast forward, and fully to stop tape playback
and release cassette tape. The car radio cassette player will automatically go into
radio mode.
5. BAND SELECTOR BUTTON
Each press for AM / FM reception. The character of band which has been selected
will be visible on the display indicating the status of tuning.
6. TUNING CONTROL
Rotate this control at radio mode to select your desired radio broadcasting station
within AM/FM. While the frequency appears on the display.
7. LCD DISPLAY
8. MO/ST BUTTON
This operation is effective on FM reception only.
In RADIO mode, press this button to change between mono or stereo sound effect.
The ST will appear on the display while there is a strong signal from an FM station
that is broadcasting in stereo. Mono improves the reception of the distant stereo FM
stations.
9. Local/Distance Reception Button
This operation is effective on FM reception only.
In RADIO mode, press this button to change between local and distant reception.
Press LOC to improve local reception in some areas where the signal is too strong.
Press LOC to improve distant reception when you are located at a weak signal location.
10,11& 12. CLOCK DISPLAY AND SETTING BUTTON
Press F/C at radio or tape mode for frequency or clock display.
Time setting:
With time appeared on the LCD display, press and hold F/C button, then press the
H and M button at the same time to adjust hour and minute.
13. BALANCE CONTROL
Rotate this knob to adjust the audio output balance of left and right speaker.
14. TONE CONTROL
Rotate this knob to adjust the TONE sound effect.
15. EXTERNAL CD INPUT JACK
This car radio cassette player can be connected to a portable CD player through this
jack.
16. RELEASE BUTTON
Press this button to eject the detachable front face panel from the chassis.
1
2
12
13
3
5
8 109
7
15
11
4
14
6
16
RIGHT
SPEAKER
3A
0.5A
RED
YELLOW
BLUE AUTO ANTENNA
GRAY
LEFT
SPEAKER
WHITE
+
B+ POWER
B+ MEMORY
BLACK GROUND
ANTENNA JACK
R.
RED
WHITE
L.
L.
R.
RCA LINE OUT
NOTE:
Speakers with load impedance less than 4 ohms could damage the equipment.
Make sure use a speaker with 4 ohms load impedances to reduce the distortion
during high volume level.
-
+
-
TONE
H
LOC
M
F/C
VOL
BD
ST
BAL
PWR
CD IN
REL
TUNE
AUTO STOP
MHzFM
-
1
-
2
PYLE Audio AT-3040 is an auto-stop car cassette player with AM/FM 2 band LCD display tuning radio. It features a theft deterrent detachable system for added security. The unit comes with a remote control for convenient operation. Other features include:
- Power supply: DC 12Volts. Negative Ground.
- Unit Dimensions: 178[W]X150[D]X50[H] mm.
- FM Frequency Range: 88MHz - 108MHz.
- AM Frequency Range: 530KHz - 1700KHz.
- LCD display for easy viewing.
- MO/ST button for changing between mono or stereo sound effect.
- Local/Distance Reception Button for improving reception in different locations.
- Clock display and setting buttons.
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
Other documents
-
Pyle PLCDCS90M Owner's manual
-
Radio Shack PLCDCS 200 User manual
-
Sanyo MAR-B3089 Operating Instructions Manual
-
Audiovox P-49 User manual
-
-
-
Standard Horizon MST70 Owner's manual
-
Audiovox Rampage AV-428 User manual
-
-
Nextar NCS102 User manual