Discount Car Stereo BLU-CHRY98 Installation guide

Type
Installation guide
Courtesy of: DiscountCarStereo.com
Serving the internet community since 1995
BLU-CHRY98
QUICK START INSTALLATION GUIDE FOR 1998-01 CHRYSLER RADIOS WITH CD-C BUTTON
created August 10, 2015
Revised: July 19, 2022
PRODUCT SAFETY & DISCLAIMER
READ ALL INSTRUCTIONS CAREFULLY BEFORE INSTALLING, FAILURE TO DO SO MAY CAUSE
PERSONAL INJURY OR DAMAGE TO PRODUCT AND/OR PROPERTY
This installation guide is provided as a GENERAL installation guide, some vehicles vary and may
require additional steps. We do not accept responsibility for third party labor charges or
modifications. Exercise due-diligence when installing this product.
We do not accept any responsibility for vehicle damage or personal injury resulting from the
installation of this product.
Careless installation and operation can result in equipment damage.
Requirement
Radio with 8-pin CD changer port and CD-C button
Introduction- newest version 10.23
Many with older cars looking for a simply way to play audio devices without
replacing the radio will be pleased to find this solution. The BLU-CHRY98 adapter
provides a wireless music streaming solution for Smartphone, Kindle, Tablet with
A2DP profile. A wireless connection means no wires, clutter or complicated setup.
The BLU-CHRY98 music streaming solution is applicable to select 1998-01 Chrysler
rounded face radios with CDC-C button and connect to the 8-pin CD port (See Fig.
2) which guarantees the best possible sound. This module replaces Chrysler CD
changer (if present).
See Frequently Asked question at the end of this guide for details.
Introduction
Radio removal required to gain access to the connectors. Vehicle specific radio
removal is not part of this guide; however, these are available upon request.
1. Connect right angle 8-pin plug (See Fig. 1) to radio 8-pin connector (See
Fig. 2)
Fig. 1
2. Connect right angle 8-pin plug (See Fig. 1) to radio (See Fig. 2)
Fig. 2
8-pin connector
3. Connect/tap RED wire to switched/Accessory supply in vehicle.
We recommend radio accessory wire on radio speaker/power plug.
Warning; Red wire must only be connected to accessory/switched supply.
Permanent/Battery supply will drain car battery and is not recommended.
4. Secure module and proceed to “Pairing”.
Pairing
Pairing process varies among devices but basic steps are the same. This process is
done upon initial install and will not have to be repeated each time you enter/exit
vehicle.
1. Turn Ignition and radio “ON”
2. On A2DP device: go to
Settings, Wireless & Networks, Bluetooth
Settings
3. Select
Bluetooth
and turn on.
4. Then select Bluetooth settings
5. Tap
Scan for devices
.
6. Wait for Bluetooth device name to appear (Sky) and select it.
(See Fig. 3)
Blue LED inside module glows steady (paired)
Fig. 3
Operation
1. Turn ignition to “ACC” and radio “ON”
2. Press radio CD-C” button to enter Bluetooth mode.
Radio display will change to default CD changer mode: Disc 6 track 1 as
seen in Fig. 5
Fig. 5
3. Launch audio application on Smartphone or Tablet and check that volume
on device is set to 80% or more
4. Use radio volume control button to set playback level.
5.
Warning: Playlist, Track selection, text display etc. is *NOT* possible
from the Chrysler radio. Use the audio devices built-in controls or
purchase optional remote control to control audio files.
6. If correct operation is confirmed go ahead and reinstall radio.
Optional remote control
Optional remote control allows users to:
1. Control music wirelessly
2. Track up/down
3. Volume up/down
Pairing:
Operation:
Use wireless remote to perform the following functions on any iOS7.0 and higher or
Android 4.4 and higher.
Package contents:
Frequent ask questions & troubleshooting
1. Will the BLU-CHRY98 work on all Chrysler 8-pin radios?
NO; Works only on radios with 8-pin CD port and CD-C button on faceplate.
Warning: Some Chrysler export (e.g., Europe, Australia etc.) radios (e.g., RAD)
have a CD-C button and 10-pin CD port (instead of 8-pin). These CD-C button
radios requires our BLU-CHRY02. Please check radio prior to ordering.
Older square face radios with 8-pin port require our A2D-CHRY
2. My radio has a round face” and Mode button. Will the BLU-CHRY98 work?
NO; Chrysler radios with Mode button and Changer controls requires our BLU-
CHRY02.
3. Can I use the BLU-CHRY98 to make/receive phone calls?
NO; The BLU-CHRY98 supports Bluetooth music streaming only and does not
support hands-free calls.
4. Will I have to disconnect the remote CD changer?
YES, this module connects to radio 8-pin CD changer port. Any and all devices
using this port will need to be disconnected.
5. Can I use the radio buttons to control my Bluetooth device?
NO; Radio button do not control Bluetooth device. You must use devices built-in
control and display to access music apps etc. Use radio volume controls to set
playback level.
Disclaimer
• This product has no affiliation with Chrysler
• We’re not liable for misuse of this product.
•We recommend professional installation
Email support@discountcarstereo.com
© 1995-Jul-22 Discount Car Stereo, Inc. All rights reserved. Information in this document is subject
to change without notice. Other products and companies referred to herein are trademarks or
registered trademarks of their respective companies or mark holders.
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5

Discount Car Stereo BLU-CHRY98 Installation guide

Type
Installation guide

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI