FläktGroup EUSA Silencer Installation guide

  • Hello! I've reviewed the user manual for the Silencer EUSA. This document provides detailed information about maintaining the unit, including specific cleaning methods for both removable and non-removable baffles. I'm ready to answer any questions you might have about the procedures described.
  • What cleaning methods are recommended for removable baffles?
    How do I clean non-removable baffles?
    Can I use any detergent for cleaning?
Silencer EUSA
Fläkt Woods 3935 GB 03.01 1 Specifications are subject to alteration without notice
EU Air Handling Unit MAINTENANCE
Ordinary grease-dissolving and disinfecting detergents
may be used.
The cleaning method should be adapted to suit the natu-
re of the surface coating on the installed baffle.
1. Vacuum cleaning (for G-fabric + Cleantec).
2. Wash after hosing with water (Cleantec). A suitable
detergent may be added if the surfaces are contamina-
ted with grease.
NOTE.
Dirt and any water must be removed by suitable means
after cleaning and before reassembly.
Washing removed baffles with a Cleantec
surface coating
Cleaning
1. Open the hatch(es).
2. Remove the door pillar and its catch (double inspec-
tion doors); see below.
3. Pull out the acoustic baffles.
4. Clean the baffles.
5. Refit in the reverse sequence.
Removable baffles
If the doors cannot be opened fully to permit the baff-
les to be pulled out, remove the upper hinge pin and
lift off the door.
Non-removable baffles
Cleaning
The cleaning method should be adapted to suit the natu-
re of the surface coating on the installed baffle.
1. Vacuum cleaning or dry wiping with a duster on an
extension pole. NOTE. Sufficient space must be avai-
lable in neighbouring components (for G-fabric +
Cleantec).
2. Clean with a sponge and a suitable detergent.
(Cleantec).
/