FläktGroup LQSA Silencer Installation guide

I have reviewed the maintenance guide for the FläktGroup LQSA Silencer. This document provides instructions for cleaning both removable and non-removable baffles, including the proper use of vacuum cleaning, water washing, and detergents for different surface coatings. I am ready to help clarify any questions you might have about the maintenance procedures described in the manual.
What cleaning methods should be used for G-fabric or Cleantec baffles?

How to clean removable baffles?

How to clean non-removable baffles?

FläktGroup DC_9209GB 20180412_R0 Speciﬁcations are subject to alteration without notice

SILENCER LQSA

MAINTENANCE

CLEANING

1. Open the hatch(es).

2. Remove the door pillar and its catch (double inspection doors);

see below.

3. Pull out the acoustic baffles.

4. Clean the baffles.

5. Refit in the reverse sequence.

REMOVABLE BAFFLES

If the doors cannot be opened fully to permit the baffles to be pulled

out, remove the upper hinge pin and lift off the door.

The cleaning method should be adapted to suit the nature of the

surface coating on the installed baffle.

1. Vacuum cleaning (for G-fabric + Cleantec).

2. Wash after hosing with water (Cleantec). A suitable detergent may

be added if the surfaces are contaminated with grease.

NOTE.

Dirt and any water must be removed by suitable means after cleaning

and before reassembly.

WASHING REMOVED BAFFLES WITH A CLEANTEC SURFACE COATING

Ordinary grease-dissolving and disinfecting detergents may be used.

NON-REMOVABLE BAFFLES

CLEANING

The cleaning method should be adapted to suit the nature of the surface

coating on the installed baffle.

1. Vacuum cleaning or dry wiping with a duster on an extension

pole. NOTE. Sufficient space must be available in neighbouring

components (for G-fabric + Cleantec).

2. Clean with a sponge and a suitable detergent. (Cleantec).