FläktGroup EUTA Angle section Installation guide

Hello! I've reviewed the maintenance instructions for the Fläkt Woods EUTA Angle section, which outlines the cleaning procedures for sound baffle elements. The document covers disassembly steps, proper tool use, and safe water handling during cleaning. I'm ready to assist with any questions you might have about this procedure.
What should be done if the angle section cannot be accessed from another functional section?

What can be used to clean baffle elements?

What methods can be used to clean baffle elements?

What should be avoided while cleaning with water?

Fläkt Woods 3188 GB 03.01 1 Specifications are subject to alteration without notice

EU Air Handling Unit MAINTENANCE

EUTA Angle section

Vertical connection, with sound baffle elements

b = 6

c = 6-7

dd = 00

c = 6-7

b = 5

b = 7

c = 6-7

dd = 00

c = 6-7

b = 8

Cleaning

1. If the angle section cannot be accessed from another

functional section in the unit, proceed as follows:

Dismantle the wall element in the end wall of the

angle section.

2. Because the sound baffle elements are permanently

mounted, use a suitable tool that is long enough to

reach all the way in between the baffle elements inside

the air handling unit.

3. Clean the baffle elements.

4. Refit the wall element.

Select the cleaning method that is appropriate for the

type of baffle elements installed. The choice lies between

the following methods:

1. Vacuum cleaning or dry wiping with a duster on an

extension pole (G-fabric + Cleantec).

2. Cleaning with a sponge and detergent (Cleantec).

CAUTION!

Remove any remaining dirt and water in a suitable man-

ner after cleaning and before starting the unit.

Take care with water to ensure that it does not penetrate

the joint between the panel and the frame (not applicable

to EUWA).

For washing baffles with a Cleantec surface

layer

Ordinary detergents with grease solvent and disinfecting

properties may be used.