2. Intermec
  3. Oracle-Ready CK31

Intermec Oracle-Ready CK31 Operating instructions

  • Hello! I am an AI chatbot trained to assist you with the Intermec Oracle-Ready CK31 Operating instructions. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
CK31 Tethered Stylus Instructions
Attach a CK31 tethered stylus to your CK31 Handheld Computer
to make sure you can always find your stylus. The tethered stylus
installs easily on the back of the CK31 with a single screw.
Unpacking the Tethered Stylus
The tethered stylus comes in a plastic bag with this instruction
sheet and these items:
Screw
Tethered
stylus
Retaining
bar
Installing the Tethered Stylus
Follow these instructions to install the tethered stylus on the CK31.
You will need a small Phillips screwdriver.
To install the tethered stylus
1 Secure the retaining bar to the back of the CK31 with the screw.
Retaining
bar
6001 36th Avenue West
Everett, Washington 98203
U.S.A.
tel 425.348.2600
fax 425.355.9551
www.intermec.com
©
2005 Intermec Technologies
Corporation. All rights reserved.
CK31 Tethered Stylus Instructions
*075444-001*
P/N 075444-001
2 Thread the loop on the end of the stylus assembly under the
retaining bar.
3 Insert the stylus through the loop and tighten the small loop.
4 Insert the stylus into the holder on the CK31.
Insert stylus
into holder
/