EN-V231-0024-AB
Extension card fitting guide
for the central unit:
Residential
EC standards:
The 2-door extension card fitted to an INTRATONE central unit complies with the R&TTE 1999/5/CE directive: electrical
safety standard EN 60950(2001) applied, EMC standard EN 301 489-3 (2002) applied, radio standard EN 300 220-3 (2001)
applied.
Commercial references:
The 2-door extension card can be used with INTRATONE central units.
Important note:
Before connecting the extension card, ensure that the central unit has been turned off. Any connection
made while the central unit is on may result in malfunctions which will not be covered by the
manufacturer's warranty.
Physical presentation:
Ribbon cable for connection to the central unit
31
32
33
34
35
36
37
38
39
C
R
T
41
42
4
3
44
45
46
47
48
49
C
R
T
Fixing
clips
Extension card
Page 2
Fitting procedure:
Stage 1
: unscrew the hood's 2 screws
Stage 3
: turn over the central unit and move the
four tabs vertically.
Stage 4
: withdraw the central unit's housing, turn over the
stainless steel base then insert the extension card's four
clips into the four holes in the base.
Stage 2
: lift off the cover
Stainless
steel base
Housing
(Front)
(front)
Tab after
operation
tab.
Tab
before
operation
tab.
Holes for
extension card
(Back)
Page 3
Motherboard
front view
Stage 6
: replace the central unit's housing on
the stainless steel base.
Stage 7: turn over the central unit and move the
four tabs at an angle.
Stage 5
: bring the central unit's housing closer, and
connect the extension card ribbon cable to the
motherboard (display toward the top).
Motherboard turned over and mounted on
the Intratone central unit housing
(front)
(Front)
Tab after
operation
Tab
before
operation
Tab.
Tab.
(Back)
Page 4
Stage 8
: connect one or two proximity readers
(according to your needs) to the extension card.
Stage 9
: screw the hood to the central unit's
housing.
The central unit is ready to
be used
.
Proximity reader
Proximity reader
(Front)
/
