2-3S Lipo or 5-9 NiMH
1/10th Touring Car, Buggy, Truggy,Rock crawler
540,550,775 Size Motor: 12T or RPM3000 @7.2V
540,550,775 Size Motor: 12T or RPM3000 @7.2V
3A / 6A (Switch Mode)
36.5x32x18mm / 39 g
Fwd/Br
Z-E0113
30A/180A
60A/360AFwd.Cont. / Peak Current
Voltage Range
Cars Applicable
2S Lipo or 6 NiMH
3S Lipo or 9 NiMH
Resistance
BEC Output
Dimension / Weight
Running Modes
Motor
Limit
*
RC4WD Outcry III Waterproof ESC
14.50MM[0.57in]
36.00MM[1.42in]
16.50MM[0.65in]
18.00MM[0.71in]
30.00MM[1.18in]
39.60MM[1.56in]
On/Off Switch 100mm
Battery Leads
(Tamiya Connector)
Motor Leads
(Bullet Connector)
I.Battery & Operating mode
How to Set Parameters
for the 1st time, the
brake function is frequently used in steering. Therefore, this mode is often used in daily practice.
1. Outcry III ESC uses jumper caps to set running mode & battery type.
We suggest users using tweezers or needle-nose pliers to set parameters by plugging / unplugging the jumper cap (as
the battery pin header.
• Water-proof and dust-proof, suitable for all-weather conditions.
• Small size with built-in capacitor module.
• Great current endurance capability.
• Great built-in BEC output capacity.
• Automatic throttle range calibration, easy to use.
• ESC parameters can be easily changed by changing the jumper pins.
protection / Throttle signal loss protection.
output will be cut off and won’t be resumed again.
output will be cut off and won’t be resumed again
the output will be cut off and won’t be resumed again.
degrees Fahrenheit.
3. Throttle signal loss protection: The ESC will cut off the output power if the throttle signal has been lost for 0.1 second.
Protection Features
Programmable ltems
FEATURES
touch the ground.
3.This product is waterproof. Product will be functional in up to 10cm of water for 2 hours.
Bashing
Race Mode
Rock Crawling
/
