2. BLOTZ
  3. B28-SFW-200

BLOTZ B28-SFW-200 Assembly Instructions

  • Hello! I've reviewed the instructions for the BLOTZ Hanging Consoles B28-SFW-200. This document provides a guide on how to assemble the consoles, mentioning required tools such as glue and modeling knife. It also explains mounting the assembled console. I'm ready to answer your questions about the product and its assembly process.
  • What is needed for assembly?
    What should you do before starting?
    Where to hang the console once dry?
28mm Sci-Fi Walls – Hanging Consoles
B28-SFW-200
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and
remember to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place
while you allow glue to dry.
Each console is formed from the pieces shown
above.
Glue the light bar between the two uprights, with the
detail facing the same direction as the hooks.
Add the other pieces as shown above.
Once dry, hang the consoles on a blank side of a pillar.
/