AV Access HDIP120 User manual

Category
Video splitters
Type
User manual

AV Access HDIP120 is a 1080P HDMI over IP extender set that allows you to extend HDMI signals from a source device to one or multiple displays through a Cat 5a/6 cable up to 120 meters. It supports resolutions up to 1080P@60Hz and features an HDMI loop-out on the transmitter for easy monitoring of the source signal. With IR extension, you can control the source device from a remote location. Ideal for homes and offices, the HDIP120 is easy to install and use, making it a great choice for distributing HDMI signals over long distances.

AV Access HDIP120 is a 1080P HDMI over IP extender set that allows you to extend HDMI signals from a source device to one or multiple displays through a Cat 5a/6 cable up to 120 meters. It supports resolutions up to 1080P@60Hz and features an HDMI loop-out on the transmitter for easy monitoring of the source signal. With IR extension, you can control the source device from a remote location. Ideal for homes and offices, the HDIP120 is easy to install and use, making it a great choice for distributing HDMI signals over long distances.

1080P HDMI over IP Extender
User Manual
HDIP120
Introduction
Introduction
Overview
The 1080P HDMI over IP Extender set can extend HDMI signals from a
source device to one or multiple displays through a Cat 5a/6 cable up to
120 meters. It is ideal for home and offices.
Features
Transmits 1080P HDMI signals up to 120 meters through a Cat 5e/6
cable.
Distributes HDMI input signal from one transmitter to up to 10
receivers.
HDMI loop-out on the transmitter to connect to a local display,
allows easy monitoring of the source signal.
IR extension allows you to control the source device from a remote
location.
Package Contents
Before you start the installation of the product, please check the
package contents:
Transmitter x 1
Receiver x 1
Power Adapters (DC 5V/1A) x 2
IR Emitter x 1
Broadband IR Receiver (30-50KHz) x 1
Mounting Brackets (with Screws) x 4
User Manual x 1
Introduction
Panel
Transmitter
Features and Ports
1. Power input port | 2. Reset Key and Led | 3. HDMI In port | 4. HDMI Out
port | 5. IR Out port | 6. LAN port | 7. Power Led | 8. Link Led | 9. HDMI In
Led
Receiver
Features and Ports
a. Power input port | b. Reset Key and Led | c. HDMI Out port | d. IR In
port | e. LAN port | f. Power Led | g. Link Led
Installation and Application
Installation and Application
Bracket Installation
Note: Before installation, please ensure the device is disconnected
from the power source.
1. Position and install the mounting
brackets using the mounting screws
provided.
2. Repeat step 1 for the other side of the
device.
3. Attach the brackets to the surface you
want to hold the device against using
the screws (not included).
Application
(1) 1-1
TV
DVD Player
IR Emitter
IR Receiver
DVD Player Remote
TV
Transmitter Receiver
Specifications
(2) 1 - N
TV
IR Receiver
Receiver 1
Network Switch
TV
DVD Player
IR Emitter
IR Receiver
DVD Player Remote
TV
Transmitter
Receiver (N)
...
Note: One transmitter can be linked to N (N 10) receivers in the same
LAN.
Specifications
Technical
Input A/V Port
Transmitter: 1 x HDMI; Receiver: 1 x LAN
Input Resolutions
Up to 1080P@60Hz
Output A/V Port
Transmitter: 1 x HDMI, 1 x LAN; Receiver: 1 x HDMI
Output Resolutions
Up to 1080P@60Hz
Compliance
HDMI 1.3, HDCP 1.4
Transmission Distance
120m/394ft
General
Operating
Temperature
+32°F ~ +113°F (0°C ~ +45°C), 10% ~ 90%,
non-condensing
Storage Temperature
-4°F ~ 140°F (-20°C ~ +70°C), 10% ~ 90%,
non-condensing
Power Supply
DC 5V 1A
Power Consumption
Transmitter: 3.5W (Max); Receiver: 1.6W (Max)
ESD Protection
Human body model:
±8kV (air-gap discharge)/±4kV (contact discharge)
Dimensions
(W x H x D)
140mm x 21mm x 80mm/5.5'' x 0.83'' x 3.15" each for
Transmitter and Receiver
Net Weight
Transmitter: 0.3kg/0.66lb; Receiver: 0.29kg/0.64lb
Warranty
Warranty
Products are backed by a limited 1-year parts and labor warranty. For the
following cases AV Access Technology Limited shall charge for the service(s)
claimed for the product if the product is still remediable and the warranty
card becomes unenforceable or inapplicable.
1. The original serial number (specified by AV Access Technology Limited)
labeled on the product has been removed, erased, replaced, defaced or
is illegible.
2. The warranty has expired.
3. The defects are caused by the fact that the product is repaired,
dismantled or altered by anyone that is not from an AV Access
Technology Limited authorized service partner. The defects are caused
by the fact that the product is used or handled improperly, roughly or
not as instructed in the applicable User Guide.
4. The defects are caused by any force majeure including but not limited to
accidents, fire, earthquake, lightning, tsunami and war.
5. The service, configuration and gifts promised by salesman only but not
covered by normal contract.
6. AV Access Technology Limited preserves the right for interpretation of
these cases above and to make changes to them at any time without
notice.
Thank you for choosing products from AV Access.
If you have any question, please contact us via the following emails:
General Enquiry: info@avaccess.com
Customer/Technical Support: support@avaccess.com
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6

AV Access HDIP120 User manual

Category
Video splitters
Type
User manual

AV Access HDIP120 is a 1080P HDMI over IP extender set that allows you to extend HDMI signals from a source device to one or multiple displays through a Cat 5a/6 cable up to 120 meters. It supports resolutions up to 1080P@60Hz and features an HDMI loop-out on the transmitter for easy monitoring of the source signal. With IR extension, you can control the source device from a remote location. Ideal for homes and offices, the HDIP120 is easy to install and use, making it a great choice for distributing HDMI signals over long distances.

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI