KONSTANT COBA2250 User manual

Type
User manual
POWER
BARROW
ELECTRIC DUMPER
INSTRUCTION MANUAL
CONGRATULATIONS
And thank you for purchasing a new E Barrow.
We have done our utmost to ensure your E Barrow will be the most trouble free and
productive machine you will ever use. Please read the operators manual carefully
before using your E Barrow.
HINTS FOR SAFE OPERATION
DO Study this manual before operating your E Barrow.
DO Check all nuts, bolts, and wheel studs weekly.
DO Use appropriate work clothing with protective helmet and safety
shoes.
DO Exercise extreme caution with the controls when working on steep
or slippery surfaces. Especially, when people are near to the
working area.
DO Always drive the machine with both hands on the steering handler
bar.
DO Ensure that all safety guards are in place when operating the E
Barrow
ATTENTION
DO Keep the E Barrow free of any accumulation of dirt, grease, oil or
other flammable material.
DO After use connect the Barrow to the supplied battery charger. The
battery charger should be left powered up and connected to the E
Barrow until the E Barrow is next used. This will ensure that the
batteries are fully charged when the Barrow is next to be used.
Note that there is an inhibit on the drive motor whilst the battery
charger is plugged into the E Barrow socket.
SAFETY
DO NOT Allow anyone lacking in experience to operate your E Barrow.
DO NOT Carry “passengers” on your E Barrow.
DO NOT Start work without completing the daily maintenance checks.
DO NOT Operate the E Barrow without exercising appropriate safety
precautions.
DO NOT Use other types of battery charger or batteries.
DO NOT Pressure wash directly onto the Barrows electronics.
BE SAFE : EXERCISE COMMON SENSE AT ALL TIMES.
OPERATING INSTRUCTIONS:
GETTING STARTED:
1. Switch on the main power, using the battery charger cable, charge the
batteries until the “Battery symbol” full load.
2. For first time use, please switch on the main power.
TO STOP:
1. Release all the control lever. The E Barrow will slow down and stop.
After a short delay the parking brake will automatically come on.
2. Turn the key switch to “Off” position.
TO EMERGENCY STOP:
1. Push the red button.
2. Turn the red button to right for reset the emergency stop.
TO MOVE FORWARD:
1. Turn the key switch to “On” position.
2. Select the switch D on the right control clutch.
3. Select the switch (max speed 2km/h) or (max speed
4km/h) or (max speed 6km/h)
4. Hold the handlebars straight, pull up on the left hand lever & Turn the
right handle for the machine to start.
TO REVERSE:
1. Release the left hand Deadman Lever to stop the E Barrow.
2. Select the switch R on the right control clutch.
3. Hold the handlebars straight, pull up on the left hand lever & Turn the
right handle for the machine to start.
NOTE:
For long time no use, please fully charge and turn off the main power.
TO EMPTY / RESET SKIP:
Stop the machine, press switch E on the panel
Empty
Reset
NOTE: Make sure the front of E barrow no people
TO CHARGE THE BATTERY:
1. Connect the power line with the charging interface, then connect the
plug to the main power.
2. After charging, please disconnect the plug first, then disconnect the
power line with charging interface.
NOTE:
Violation of the above operation may result in damage to the machine
or personal injury!!!
MAINTENANCE
Routine checks of your E Barrow will ensure trouble free operation with
less ’down’ time.
Component
Daily
Weekly
State of battery charge
Control Cables
Condition of wiring
Tyre Pressure
All Nuts/Bolts
Tyre Pressures
Front Wheel
30 psi
Rear Wheel
30 psi
Remember – A daily check takes only minutes but could save you hours.
Be Proud – look after your E Barrow.
MACHINE OPERATING:
CIRCUIT DIAGRAM
OPTIONAL ACCESSORIES:
1
Attachment 1# : Flatbed
Length: 500mm
Width: 500mm
Thickness: 21mm
Weight: 19kgs
2
Attachment 2# : Ball Hitch
Ball Size:50mm
Product size:390*380*145mm
Max draw capacity:1500kg
Weight : 9.5kg
3
Attachment 3#: Snow blade
Length:850mm
Height: 560mm
Weight: 30kgs
4
Attachment 4#: Extension Sides
Length: 830mm
Height: 400mm
Dry Weight: 26.6kgs
5
Attachment 5#: Turf Tyre
Size: 20*10-8
Connecting Adaptor: Included
Weight: 8kgs/pc
IF NEED THESE ACCESSORIES, PLEASE CONTACT SALESMAN.
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8
  • Page 9 9

KONSTANT COBA2250 User manual

Type
User manual

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI