GABLE RAKE FLASHING - #GR-2
INSTALLATION GUIDELINES
These installation guidelines are for use with typical or standard applica-
tions. Refer to the detail installation guide for panel and flashing install
details. It is always recommended to seek advice from a licensed profes-
sional, and to check with your local building inspector or building permit
office for approvals and possible variations that may apply.
CAUTION!
Working above grade is inherently dangerous, be sure
that proper fall protection measures are in place.
When working with power tools and sheet metal, gloves
and eye protection are absolutely required.
SM-Rib Panel
SM-Rib Panel
Inside Closure
#30 Felt min.
#9 x 1-1/2" ScrewGR-2
Butyl Tape
4 ⁄ in.
11.9 cm
4 ⁄ in.
11.9 cm
1 ⁄ in.
2.7 cm
¾ in.
1.9 cm
1 ⁄ in.
2.7 cm
⁄ in.
9.5 mm