Generation Lighting 7737302EN3-962 Installation guide

Brand
Generation Lighting
Model
7737302EN3-962
Type
Installation guide
1
Installation Instructions for
1.0
990C7737302-EWP
7737302
Elmwood Park 2 Light Flush Mount
GP I :ENERAL RODUCT NFORMATION
These fixtures are intended to be installed utilizing compliant junctionNEC
boxes.
This product is safety listed for damp locations.
Incandescent version may be dimmed with a standard incandescent dimmer.
LED LEDversion may be dimmed with a dimmer. Consult lamp manufacturer
for additional information.
This instruction shows a typical installation.
CAUTION RISK OF FIRE-
This product must be installed in accordance with the applicable
installation code by a person familiar with the construction and
operation of the product and the hazards involved.
Use minimum 90°c supply conductors.
7400 Linder Ave, Skokie, 160077IL
800.969.3347
www.generationlighting.com
© 2019 Generation Lighting.All rights reserved.
The "Generation Lighting" graphic is a registered trademark of
Generation Lighting. Generation Lighting reserves the right to
change specifications for product improvements without notification.
SAVETHESE INSTRUCTIONS!
Ceiling
2
1A
Secure the mounting plate to the junction box.
Connect the fixture to a suitable ground in accordance to local electrical codes.
Connect the white fixture wire to the neutral power line wire with a wire nut.
Connect the black fixture wire to the hot power line wire with a wire nut.
Place the fixture base onto the mounting plate studs and secure it in place by screwing the cap nuts onto the mounting
plate studs.
Screw the lamps into the sockets. Refer to the label on the socket for Max Wattage Information.
Screw the threaded pipe to the bottom of the socket assembly.
Attach the outer shade to the shade base with the thumb screws and caps.
Place a steel washer, rubber washer, the shade, rubber washer, and steel washer (in that order) onto the threaded pipe,
then secure them in place by screwing a hex nut onto the threaded pipe.
Place the cup onto the threaded pipe and secure it by screwing the finial onto the threaded pipe.
1
2
3
4
5
FIXTURE BASE
Install the Fixture
JUNCTION BOX
MOUNTING PLATE STUD
MOUNTING PLATE
34
6
7
8
9
CAP
OUTER
SHADE
SOCKET ASSEMBLY
HEX NUT
FINIAL
CUP
THREADED PIPE
RUBBER WASHER
STEEL WASHER
9
10
STEEL WASHER
RUBBER WASHER
8
INNER
SHADE
CAP NUT
5
5
THUMB SCREW
1
6
6
7
10
SHADE BASE
  • Page 1 1
  • Page 2 2

Generation Lighting 7737302EN3-962 Installation guide

Brand
Generation Lighting
Model
7737302EN3-962
Type
Installation guide
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents