1. Place the top corner bracket into the
2. Position bracket behind the rubber
bead and carefully push until the metal
bracket is square to the sides of the bead
3. Place the bottom corner bracket into
You will need:
•
•
•
•
Note: The above should be supplied
4. Position bracket behind the rubber
5.
6. Slide the side extrusion up until it
The side extrusion should rest under
of the extrusion over the bottom corner
9.
7. At the appropriate position(s) on each
8.
10.
will stay in position under tension from
11. If your blind requires further tension
button until you feel the blind has