Enduro Rear Wheel Spacer Kit Operating instructions

Hello! I've reviewed the provided installation instructions for the Enduro Engineering Wheel spacer kit 16-1023. This document outlines the steps to remove old wheel spacers and install the new ones, including the use of a 30mm socket. I am ready to answer your questions about the installation process or the product itself.
What size socket do I need for the axle nut?

Are the spacers different for each side of the wheel?

What is the part number for the wheel spacer kit?

REAR WHEEL SPACER KIT INSTALLATION INSTRUCTIONS

1. Using a 30mm socket remove the rear axle nut and remove the rear axle. (FIG 1 & 2)

2. Remove the rear wheel from the motorcycle.

3. Remove the rear wheel spacers from the hub of the wheel by grabbing onto the spacer and pulling outward while spinning the

spacer. (FIG 3)

4. Replace the spacer removed in step 3 with the Enduro Engineering Wheel spacer. (FIG 4) They are symmetrical and are the

same for both sides. Make sure the spacer is pressed in all the way before reinstalling the rear wheel to the motorcycle.

5. Reinstall the rear wheel onto the motorcycle. Slide the axle back through.

6. Reinstall the axle nut and tighten using a 30mm Socket.

7. Have Fun and enjoy your next ride.

REAR WHEEL SPACER KIT INSTALL INSTRUCTIONS

PART NUMBER 16-1023