CAL-ROYAL PST-201 Series Panic Saddle Threshold

Cal-Royal CAL-ROYAL PST-201 Series Panic Saddle Threshold Installation guide

  • Hello! I've reviewed the installation instructions for the CAL-ROYAL PST-201 Series Panic Saddle Threshold. This document outlines the steps for proper installation, including measuring, trimming, sealing, and fastening, as well as the materials this product is rated for with fire doors. I'm ready to answer any questions you may have about this product.
  • What is the recommended screw size for installation?
    How much longer should the seal be trimmed compared to the retainer threshold?
    What type of sealant should be used?
MATERIAL FOR USE IN LISTED STEEL FRAMES AND CLASSIFIED HOLLOW METAL STEEL COMPOSITE TYPE FIRE
DOORS ARE RATED UP TO AND INCLUDING 3 HOURS, WOOD COMPOSITE TYPE FIRE DOORS ARE RATED UP TO AND
INCLUDING 1-1/2 HOURS, AND WOOD CORE FIRE DOORS ARE RATED 20 MINUTES WITHOUT HOSE STREAM.
PST-2014FSJFT
1/2” H x 5” W
12.7 mm x 127 mm
1/2” (12.7mm) PANIC SADDLE THRESHOLD
,167$//$7,21*8,'(/,1(
1. Carefully measure to fit within the frame opening and make sure the WJOZl makes contact
with door face when door is closed.
2. If necessary trim and notch the threshold ends to accommodate the side jamb stops.
3. Trim seal 1/8” longer than the retainer threshold at each end.
4. Mark and drill pilot holes through the pre-drilled holes in the threshold and fasten with
screws provided.
Use a weatherproof sealant at all edges and joints.
5. Operate the door multiple times to ensure proper adjustment so as not to prevent the door
from self-closing and latching.
INSTALLATION INSTRUCTIONS
5
1 ⁄
⁄
⁄
⁄
6&5(:6,=([3)+:6
':*7:*0$5
f
f
rame opening and make
sure the
WJO
Z
l makes
contact
/