Atdec TH3070CTW User manual

Atdec
Brand
Atdec
Model
TH3070CTW
Category
Wall & ceiling mounts accessories
Type
User manual
Installation Addendum
TELEHOOK
TH-3070-CTW Back to Back Conversion Kit
C Attaching the Mount to the Ceiling Hanger
TM
IMPORTANT
This A
ddendum MUST be used
with th
e Installation Instructions
supplied w
ith Telehook Ceiling
Tilt (TH-3070-CTW)
(1) Follow steps A, B, C on the Telehook TH-3070-CTW Installation Instructions.
(2) Fol
low step D on Telehook TH-3070-CTW Installation Instructions and repeat for 2nd display.
(3) Fol
low steps E,F and repeat for 2nd display bracket. Once complete, continue step C below.
M8x10mm
Screw
Swivel Insert
(1) Attach the three Swivel Inserts to the hanger
at the height that has been chosen to mount the
display.
(2) Attach the two front collars to the Hanger Pole so that they sit on
the swivel inserts as shown above. Tighten the M8 x 30mm screws so
that the collars are secure on the hanger, however do not over tighten.
Swivel Insert
Col
lar Front
M8 x 30mm
Screws
Collar Front
B Refer to the Telehook TH-3070-CTW Installation Instructions
A Check Component Checklist and Product Checklist
Ensure you have received all components in both Component Checklist and Product Checklist
WARNING
Fa
ilure to follow these installation
in
structions and those in the TH-3070-CTW
may r
esult
in pe
rsonal
to Audio/Visual qui
pment
D Mounting the Display
M8 Small
Washer
M8x45mm
Screw
Hex Tool
Note: The brackets should rest on the
horizontal bar with the slider between
the bracket.
Note: This operation will require two persons
(1) Lift one of the displays with brackets attached and hook the
brackets over the sliders. Hold the display firmly, insert the two M8 x 45mm
screws and tighten firmly using the Hex Tool.
(2) Repeat for 2nd Display
injury and/or damage
Component Checklist
Bits Box
M8 x 55mm
Screw
M6 x 12mm
Grub Screw (x3)
3mm Allen Key
6mm Allen Key
Collar Front
M5 x16mm
Mounting
Screws (x6)
M6 x16mm
Mounting
Screws (x6)
M8 x16mm
Mounting
Screws (x6)
M4 x16mm
Mounting
Screws (x6)
5mm Allen Key
M8 x45mm
Locking Screws
(x2)
M8 Small
Washer
(x2)
Multi
Washer (x6)
Wall Mount
Horizontal Bar
Slider (x2)
Wall Mount
Bracket (Left)
Wall Mount
Bracket (Right)
Product check list:
1 x TH-3070-CTW (separate product)
1 x Back-to-Back conversion kit
E Adjusting the viewing position of your display
M8 Small
Washer
M8 x 45mm
Screw
Hex Tool
Tighten
Loosen
(1) Loosen both M8x45mm screws on
one of the display brackets, and adjust
the tilt angle of the display to the
required position. Tighten the two lock-
ing screws with Hex Tool provided.
(2) Repeat for 2nd Display
WARNING: Do not attempt to
adjust tilt angle without firstly
loosening locking screws. Doing
so may damage the product.
-5° to 5°
3. Horizontal Adjust
2
1
3
Horizontal Bar
(1) To adjust the pan position of the display, loosen all four
M8 x 30mm screws with the 6mm Allen Key, then rotate the Hanger
Pole Collar to the desired position. Once in position, tighten all four
M8 x 30mm screws as tight as possible to lock the display in position.
Tighten
360° Rotation
6mm Allen Key
2. Pan Adjust
-5° to 25° Tilt
-5° to 25° Tilt
Follow steps K and L in the Telehook TH-3070-CTW Installation Instructions to attach adhesive vinyl and apply
ad
ditional secu
rity
1. Tilt Adjust
TFT Manufacturers are constantly releasing new monitor models, Atdec does not accept responsibility if the mounting hole pattern does not comply with
the international VESA standards. Due to continuing product development, the manufacturer reserves the right to alter specifications without notice.
Published: 12.12.08 ©
F Refer to the Telehook TH-3070-CTW Installation Instructions
(1) Adjust grub screw 1 until the display sits
level. Once the display is level, tighten grub
screw
2 until it firmly tightens onto the
horizontal bar. Tighten grub screw
3 until it
firmly tightens onto the horizontal bar and
prevents it from moving.
(2) Repeat for 2nd Display Bracket
if required.
  • Page 1 1
  • Page 2 2

Atdec TH3070CTW User manual

Atdec
Brand
Atdec
Model
TH3070CTW
Category
Wall & ceiling mounts accessories
Type
User manual
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents