Brodit 834965 Datasheet

Product 834965

834965 ProClip

Console mount

The ProClip is a mounting bracket for the vehicle’s dashboard. Onto the ProClip you can install e.g. a holder for

your mobile phone or PDA or a handsfree set etc. Safe and convenient -always within easy reach. The ProClip is

car specific and easy to install. The installation is quick, no special tools or dismantle of the dashboard is required

and it will not damage the interior of the vehicle. Made in black ABS plastic. Comes with detailed instructions.

EAN: 7320288349657

Item no 834965 fits:

Cadillac CTS 08-13 (For USA)

Cadillac CTS Coupe 11-13 (For USA)

1(2)

1. 2.

INSTALLATION INSTRUCTIONS

4.3.

Please read the instructions and look at the pictures before installing the ProClip.

1. Use the enclosed alcohol pad to clean the area where the ProClip is installed. Peel off the adhesive tape cover

on the ProClip. Hook the lower angled edge of the ProClip under the console right side panel by the carpet.

2. inser the enclosed gap opener between the center console panel and the console side panel, to widen the gap.

Then with your fingers under the upper part of the the ProClip, flex the upper angled edge over the top of the

console top and place the angled edge on the elft side of the ProClip and into the gap in the seam next to the gap

opener. Pull out the gap opener.

3. Press down on top of the angled edge of the ProClip to ensure it is all the way into the seam.

4. The ProClip is in place.

2(2)

Download PDF