Gilson,Inc. | PO Box 620027 | Middleton, WI 53562-0027 | Tel: 608-836-1551 OR 800-445-7661 | Fax: 608-831-4451
GilsonS.A.S. | 19, avenue des Entrepreneurs | BP 145, F-95400 Villiers-le-bel, FRANCE
www.gilson.com | sales@gilson.com | ser[email protected] | [email protected]
Installation Instructions
GX-27X System Organizer
Part Number 21050000
LT319019-03 | Page 1 of 2
This document contains instructions for assembling the
GX-27X System Organizer for use with the GX-271 and
GX-274 systems.
Parts
The GX-27X System Organizer includes the following:
● Right side assembly
● Left side assembly
● Shelves (x2)
● Phillips screws (x24)
A medium-sized Phillips screwdriver is required for this
installation.
Attaching the Shelves
1. Lay the left side assembly down on the oor with
the beveled edge facing the oor and the foot of the
assembly facing the front.
NOTE
If the color strip faces the right in this
position, it is the right side assembly.
2. Take one of the shelves and align the holes on the back
of the shelf with the lower set of holes on the back of
the left side assembly. Insert and slightly nger tighten
the Phillips screws (Figure 2).
Figure 1: GX-274 System with Organizer
Phillips
Screws
Shelf
Beveled
Edge
Left
Side
Assembly
Figure 2: Installing the Shelf on the Side Assembly (Step 2)
Page 2 of 2 LT319019-03GX-27X System Organizer Installation Instructions
3. Locate the holes on the inside of the left side assembly
and insert the Phillips screws through the hole on the
shelf and through the hole on the organizer and nger
tighten the screws (Figure 3).
4. Repeat steps 2 and 3 for the right side assembly.
5. Place the organizer in an upright position and then
install the second shelf in the same manner as the rst
shelf (Figure 4).
6. Use the Phillips screwdriver to rmly tighten all screws.
Positioning the System Organizer
1. Place the organizer just behind the top cover of the
GX-27X instrument. Ensure about an inch of clearance
between the bottom shelf and the cable support rod
on the back of the GX-27X (Figure 5).
2. Set the syringe pumps on the bottom shelf and the
solvent bottles on the top shelf.
3. Turn o the GX-27X.
4. Make all plumbing and electrical connections, utilizing
the access slots on the backs of the shelves.
5. Move the Z- and Y-arm manually to their furthest
positions to ensure the free movement of the Z-arm
and Z-arm cable.
Phillips
Screws
Side
Assembly
Figure 3: Installing the Shelf on the Side Assembly (Step 3)
Phillips Screws
Shelf
Shelf
Left
Side
Assembly
Right
Side
Assembly
Figure 4: System Organizer with Screw Locations
Figure 5: System Organizer with Proper Clearance (Side View)
≥1"
/