2. LoD Offroad
  3. JSP1831

LoD Offroad JSP1831, JSP1841 Installation guide

  • Hello! I've reviewed the installation instructions for the LoD Signature Series Skidplate, including Shorty and Mid/Fullwidth models. The document outlines the necessary steps for removing the existing crash bar and securely mounting the new skid plate using the provided hardware. I'm ready to help with any questions you may have about the installation process.
  • What size socket is needed for the installation?
    What is the first step in the installation process?
    What should be checked when opening the package?
JL18FBSPSSINS - REV 1 03/16/18 Page 1
SIGNATURE
SERIES
SKIDPLATE
MID/FULLWIDTHSHORTY
SHORTY + MID/FULLWIDTH
First remove the crash bar, there are two bolts holding it on.
After the bolts are removed, you will shift the crash bar slightly up, then pull towards you
to remove the tabs out of the opening.
JL
1.
OR
JL18FBSPSSINS - REV 1 03/16/18 Page 2
Using the two holes indicated,
under the frame mounts,
mount the supplied crash bar.
It should look like this when complete.
(re-use the stock bolts)
3.
2.
JL18FBSPSSINS - REV 1 03/16/18 Page 3
HOLD UP THE SKID PLATE TO
THE BOTTOM OF THE BUMPER
AND SECURE IT IN PLACE USING
THE BOLTS AND WASHERS
PROVIDED. YOU WILL NEED A
9/16” SOCKET FOR THE JOB.
SECURE THE SKIDPLATE TO THE
LOWER CROSS MEMBER OF YOUR
JK JEEP USING THE BOLTS AND
WASHERS PROVIDED. YOU WILL
NEED A 9/16” SOCKET FOR THIS
JOB.
4.
5.
JL18FBSPSSINS - REV 1 03/16/18 Page 4
Shorty
Mid/Fullwidth
OR
JL18FBSPSSINS - REV 1 03/16/18 Page 5
3/8”x1” Hex Head
7/16” Washers
3/8” Nuts
(x6) (x4)
(x2)
Assembled By :
Date :
Signature Series Front
Skidplate Shipping Slip
*please check contents when
opening/assembling package
JL
/