TX-W1
Wheel Kit for
TX1181 and TX2181
Installation Instructions
TX-W1 Wheel Kit
The Electro-Voice TX-W1 Wheel Kit consists of a pair of skid plates with assembled casters for use with the
TX1181 and TX2181 Loudspeakers. The skid plates also add extra protection for the rear panels of the TX1181
and TX2181. Use the following steps to mount the TX-W1 Wheel Kit to the rear panel of a TX1181 or TX2181.
1. Remove the (6) 1/4-20 bolts from the rear panel of the TX1181 or TX2181 loudspeaker.
2. Align (3) holes in the first skidplate of the TX-W1 with the top (3) holes on the loudspeaker.
3. Align (3) holes in the second skidplate of the TX-W1 with the bottom (3) holes on the loudspeaker.
4. Insert all (6) bolts through the skidplate holes and tighten into the rear panel of the loudspeaker.
12000 Portland Avenue South, Burnsville, MN 55337
Phone: 952/884-4051, Fax: 952/884-0043
www.electrovoice.com
© Bosch Communications Systems 07/2009
Part Number LIT000256 Rev A
U.S.A. and Canada only. For customer orders, contact Customer Service at:
800/392-3497 Fax: 800/955-6831
Europe, Africa, and Middle East only. For customer orders, contact Customer Service at:
+ 49 9421-706 0 Fax: + 49 9421-706 265
Other Internatonal locations. For customer orders, Contact Customer Service at:
+ 1 952 884-4051 Fax: + 1 952 887-9212
For warranty repair or service information, contact the Service Repair department at:
800/685-2606
For technical assistance, contact Technical Support at: 866/78AUDIO
Specifications subject to change without notice.
Electro-Voice
®
Figure 1: Remove Bolts from Rear Panel of Loudspeaker
Figure 2: Align holes and Tighten Bolts
Remove Mounting
Screws (x6)
TX-W1 Wheel Kit
Model Part No. Description
TX-W1
ACC000043-000 Wheel Kit for TX1181 or TX2181
TX1181 or TX2181
Loudspeaker
(TX2181 shown)
CAUTION! If the skid plates are removed, replace the
1/4-20 bolts into the rear of the loudspeaker. If the bolts
are not replaced, the loudspeaker will have air leaks
resulting in undesirable performance.
TX1181 or TX2181
Loudspeaker
(TX2181 shown)
Re-Attach Mounting
Screws (x6)
TX-W1
Skid Plate
(Bottom)
TX-W1
Skid Plate
(Top)
/
