FSR
244 Bergen Boulevard, Woodland Park, NJ 07424, Phone: 973.785.4347 - Fax: 973.785.4207
43410 LIT1811
1. REMOVE AND DISCARD TEMPORARY COVER AND SCREWS.
2. INSTALL ELECTRICAL DEVICES AND CONNECTOR PLATES IF
PREVIOUSLY NOT INSTALLED. CLEAN AREA IN AND AROUND ENTIRE
TOP EDGE OF BOX AND APPLY 1/4" CONTINUOUS BEAD OF RTV
SILICONE SEALANT.
3. INSTALL COVER WITH SUPPLIED O-RINGS AND FLAT HEAD SCREWS.
INSTALL FINISHED FLOORING MATERIAL.
FL-400 Cover Installation Instructions
(8) FLAT HEAD SCREW
TEMPORARY COVER
CLEAN AND APPLY SEALANT
AROUND ENTIRE EDGE
CLEAN AND APPLY SEALANT
AROUND ENTIRE EDGE
(8) O-RING
(8) FLAT HEAD SCREW
COVER
4. OPEN LARGE DOOR BY LIFTING AND PULLING HANDLE UPWARD AS SHOWN
(CABLE ACCESS DOOR WILL FALL INWARD IF NOT ALREADY OPEN). LARGE
DOOR CAN NOW BE ROTATED OVER TO BE FLAT ON FLOOR. CONNECT
CABLES AS REQUIRED. PRIOR TO CLOSING LARGE DOOR, SWING CABLE
ACCESS DOOR ONTO VELCRO ON UNDERSIDE OF LARGE DOOR. ROTATE
LARGE DOOR FORWARD ON IT'S HINGES, AND PUSH FIRMLY ON CORNERS
TO SNAP LARGE DOOR SECURELY IN PLACE.
CABLE ACCESS DOOR
LARGE DOOR
HANDLE
LARGE DOOR SHOWN WITH
CABLE ACCESS DOOR OPEN
/
