Argos 548/5259 Assembly Instructions Manual

Type
Assembly Instructions Manual
Assembly Instructions - Please keep for future reference
Important - Please read these instructions fully before starting assembly
kent dressing table + mirror + stool
548/5259
If you need help or have damaged or missing parts, call the Customer Helpline:
Argos = 0345 6400800
issue 1 - 9/3/16
Width - 85 cm
Depth - 40 cm
Height - 81,3 cm
Dimensions
dressing table
Width - 50 cm
Depth - 9 cm
Height - 54 cm
Dimensions
mirror
Width - 45 cm
Depth - 45 cm
Height - 46cm
Dimensions
stool
1
Important - Please read these instructions fully before starting assembly
Care and maintenance
This product should not be
discarded with household waste.
Take to your local authority
waste disposal centre.
From time to time check that
there are no loose screws on
this unit.
Only clean using a damp cloth
and mild detergent, do not use
bleach or abrasive cleaners.
Safety and Care Advice
During assembly do not stand
or put weight on the product,
this could cause damage.
Assemble the item as close
to its final position (in the same
room) as possible.
Assemble on a soft level
surface to avoid damaging the
unit or your floor.
Parts of the assembly will be
easier with 2 people.
!
Check you have all the com-
ponents and tools listed on the
following pages.
Remove all fittings from the
plastic bags and separate them
into their groups.
Keep children and animals
away from the work area, small
parts could choke if swallowed.
Make sure you have enough
space to layout the parts before
starting.
Handy Hints
Regularly check and ensure
that all bolts and fittings are
tightened properly.
Assemble all parts and bolts
loosely during assembly, only
once the product is complete
should you fully tighten the bolts.
Note: if required the next
page can be cut out and used
as reference throughout the
assembly. Keep this page with
these instructions for future
reference.
To redure
the likelihood of
damaging your
product please
ensure that your
power drill is set on a low torque
setting.
Mirror safety
Keep these instrudion fo
r
future reference
.
imported by :
Argos Ltd
489 - 499 Avebury Boulevard
Saxon Gate West
Central Milton Keynes
MK9 2NW
If the m
irror
is chipped or broken : stop using the
product and consult the Manufacturer or Supplier
.
Batch No : 524030
Date of Manufacture: Apt.2016
Type of glass used : 5mm mirror
Warning :
(a) Do not place very hot or very cold items on the mirror surface(s) unless adequately thick
table mats are used to prevent such items from coming into contact with the mirror.
(b) Do not sit or upon the mirror surfaces(s).
(c) Do not use the mirror as a chopping surface.Do not strike the mirror with hard or pointed items
(d) When cleaning mirror panels use a damp cloth or leather with washing up liquid or soft if
necessary, do not use washing powders or any other substance containing abrasives since
these substances scratch mirror.
2
Dressing Table (85 x 40 x 81,3 cm)
1
Please check you have all the panels listed below
If you have damaged or missing components, call the
Customer Helpline: Argos = 0345 6400800
Components - Panels
Mirror (50 x 9 x 54 cm)
2
Stool (45 x 45 x 46 cm)
6
Frame Mirror (36 x 4 x 47.5 cm)
3
Support Mirror (41.9 x 2.8 x 3.5 cm)
4
Base (50 x 9 x 2 cm)
5
3
Tools required
Note: The quantities below are the correct amount to complete the assembly. In some cases more
fittings may be supplied than are required.
Please check you have all the fittings listed below
Components - Fittings
170160150140130120110100908070605040302010
0
5 15 25 35 45 55 65 75 85 95 105 115 125 135 145 155 165
Ruler - Use this ruler to help correctly identify the screws
The screws length is measured from the head to the point (15 mm screw shown).
A
B
C
Bracket x 2
Bolt 30 mm x 3
Screw 15 mm x 4
D
Allen Keys x 1
0 10 20 30 40 50 60 70 80 90 100 11 0 120 130 140 150
0 1 2 3 4 5 6
Phillips screwdriver
(medium & large)
Flatblade screwdriver
(medium)
Ruler/tape
measure
Drill
7mm Suitable drill bit
(for use with wall plug)
Assembly Instructions
4
If you need help or have damaged or missing parts, call the Customer Helpline:
Argos = 0345 6400800
Step 1
Drawer handles are
pre-assembled reversely.
Disassemble the handle and
re-attach as shown in the
figure.
Assembly Instructions
5
If you need help or have damaged or missing parts, call the Customer Helpline:
Argos = 0345 6400800
Step 4
Mirror is complete.
Step 3
Step 2
Attach the Base 5 on the
Support Frame 4 using
30mm Bolts A and secure
using Allen Key D
Insert the Frame Mirror 3
on the Support Frame 4
A
D
4
5
3
Step 5
Assembly Instructions
6
Step 6
Put the Mirror on the
Dressing Table and using
Bracket C ,15mm Screw B
to the hold the Mirror and
Dressing Table.
Assembly is complete.
If you need help or have damaged or missing parts, call the Customer Helpline:
Argos = 0345 6400800
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7

Argos 548/5259 Assembly Instructions Manual

Type
Assembly Instructions Manual

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI