Assembly Instructions - Please keep for future reference
Important - Please read these instructions fully before starting assembly
Dimensions
Width - 150/180cm
Depth - 80cm
Height - 75cm
kent ext 150/180 table
532/8608
If you need help or have damaged or missing parts, call the Customer Helpline:
Argos = 0345 6400800
issue 1 - 9/3/16
1
Important - Please read these instructions fully before starting assembly
Care and maintenance
This product should not be
discarded with household waste.
Take to your local authority
waste disposal centre.
From time to time check that
there are no loose screws on
this unit.
Only clean using a damp cloth
and mild detergent, do not use
bleach or abrasive cleaners.
Safety and Care Advice
During assembly do not stand
or put weight on the product,
this could cause damage.
Assemble the item as close
to its final position (in the same
room) as possible.
Assemble on a soft level
surface to avoid damaging the
unit or your floor.
Parts of the assembly will be
easier with 2 people.
!
Check you have all the com-
ponents and tools listed on the
following pages.
Remove all fittings from the
plastic bags and separate them
into their groups.
Keep children and animals
away from the work area, small
parts could choke if swallowed.
Make sure you have enough
space to layout the parts before
starting.
Handy Hints
Regularly check and ensure
that all bolts and fittings are
tightened properly.
Assemble all parts and bolts
loosely during assembly, only
once the product is complete
should you fully tighten the bolts.
Note: if required the next
page can be cut out and used
as reference throughout the
assembly. Keep this page with
these instructions for future
reference.
To redure
the likelihood of
damaging your
product please
ensure that your
power drill is set on a low torque
setting.
2
Please check you have all the panels listed below
Top Frame (110 x 50 x 50 cm)
1
If you have damaged or missing components, call the
Customer Helpline: Argos = 0345 6400800
Components - Panels
TLegs (71.7 x 7 x 7 cm)
2
2
2
2
170160150140130120110100908070605040302010
0
5 15 25 35 45 55 65 75 85 95 105 115 125 135 145 155 165
A
Note: The quantities below are the correct amount to complete the assembly. In some cases more
fittings may be supplied than are required.
Please check you have all the fittings listed below
Components - Fittings
Ruler - Use this ruler to help correctly identify the screws
Bolts 60mm & Washers x 08
The screws length is measured from the head to the point (15 mm screw shown).
Key x 1
B
Tools required
0 10 20 30 40 50 60 70 80 90 100 11 0 120 130 140 150
0 1 2 3 4 5 6
Phillips screwdriver
(medium & large)
Flatblade screwdriver
(medium)
Small
hammer
Ruler/tape
measure
Eye protection
(when using a
hammer or glue)
Assembly Instructions
4
If you need help or have damaged or missing parts, call the Customer Helpline:
Argos = 0345 6400800
Step 1
Attach the frame legs 2
on the frame top 1 using
60mm bolts and washer
A and secure key B as
detail in the diagram
below.
2
1
A
B
Assembly Instructions
Open table
a : Release safety locks
(see safety lock instrucsion
below ). Hold to lift the table
up and pull the table top out
as shown by the arrows.
b : Open the extension
leaves.
c :Hold the top of table to
push on both sides of table
as shown by the arrows.
Use safety locks to ensure
table top will not move while
using ( see safety lock
instruction below )
a :
b :
c :
5
Assembly Instructions
Close table
a : Release safety locks
(see safety lock instrucsion
below ). Hold to lift the table
up and pull the table top out
as shown by the arrows.
b : Close the extension
leaves.
c :Hold the top of table to
push on both sides of table
as shown by the arrows.
Use safety locks to ensure
table top will not move while
using ( see safety lock
instruction below )
a :
b :
c :
6
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI