USER MANUAL
WIRED GAMING MOUSE
MG200
- Interface: USB 1.1 / USB 2.0
- Resolutions: 1000 / 1200 / 1600 / 3200 DPI
- Tracking sensor: Optical
- Sensor report rate: 3000 times per second
- Sensor tracking speed: 28 + IPS
- Supported OS: Windows 7 / 8 / 10
- Cable: 1.5m braided USB cable
- Dimensions: 123 x 69 x 41mm ( L x W x H)
- Weight: 125g (approx.)
Technical Specifications:
1.Insert the USB connector into USB port of a PC or Laptop.
2.Turn on your computer. The mouse will have basic functionality
already once the OS has loaded.
Connecting the mouse to a computer:
- Windows 7 / Windows 8 / Windows 10 Operating System interface
- USB 1.1 / 2.0
- 30MB of available hard disk space
System requirements:
1.
3.
Installation:
Unzip MG200.zip and install the software by executing the application
and navigate to www.astrumworld.com/downloads/drivers/MG200.zip
and following the steps to complete the installation. (Picture 1)
To start, plug the gaming mouse USB cable into a computer
After the installation completes, you will see the program icon
on the lower right corner of the taskbar system, double click
the icon to launch the pop-up program settings interface.
2.Click finish to complete the installation (picture 2)
4.There are 3 configuration profiles to choose from in the setup
program. Pick a configuration (Cfg1, Cfg2 or Cfg3) and modify
the settings as preferred (picture 3).
(picture 1)
(picture 2)
(picture 3)
(picture 4)
Basic settings
1. To set key 2 to be the ”back” key, you would need to select key 2
(Mid Click) on the configuration page and then click the drop-down
list box and select “back” (picture 4).
2.At this stage the key 2 configuration will be shown (picture 5).
Click on “apply” and “save settings” (picture 6).
(picture 5)
(picture 6)
advanced settings tab to enable macros.
1. Enter a name into the “name” text box (picture 7)
2. Click on the “new” button (picture 7).
3. Click “record” button, move mouse cursor to the key list and
enter a command (picture 8).
4. Click on the “stop” button and then click on the ”save” button
If you want to use more Macros functions, they can be set up here,
using the same method.
Advanced settings
Assigning Macro settings:
(picture 7)
To set 5 keys to have Macro functions, firstly choose the
1. Select the “base settings” tab to set the DPI.
2. Click “Apply” and “save settings” (Picture 9).
DPI settings
(picture 8)
(picture 9)
You can change the wheel function to volume control function
if preferred (picture 9).
Wheel function settings
You can adjust the LED settings according to your preference
(picture 10).
LED settings
®2010 ASTRUM HOLDINGS LIMITED. Astrum is a registered trademark of Astrum Holdings
Limited, Hong Kong. All Rights Reserved. All other trademarks are the property of their
respective owners. All specifications and photos are for reference purposes only .
(picture 10)
/
