Installation Guide for Beam LTE Fixed Installation Bundle (MG200-FB10 / MG200-FB20)
Beam LTE932 10m Cable
(MG200-FB10 only)
Lightning
Arrestor
(not included)
Beam LTE933 20m Cable
(MG200-FB20 only)
OR
Installation Guide for Beam LTE Fixed
Installation Bundle (MG200-FB10 / MG200-FB20)
Applications
FARM BUILDING
For more information please visit: beamcommunications.com/cellular
Optimal Antenna Installation Location
• Antenna front panel to face the service provider tower
• Antenna must be installed with a separation distance
of at least 20cm away from all persons
• Install under the cover of the lightning rod
• Keep away from heat or fumes
• Keep away from other antennas
N-Type
SMA
Beam MG200 LTE Gateway
Beam LTE720
Panel Antenna
2 x Beam LTE933 20m Cable
(MG200-FB20 only)
1 x Installation Guide1 x Beam MG200 LTE Gateway Kit
1 x Beam LTE720 Panel Antenna
2 x Beam LTE932 10m Cable
(MG200-FB10 only)
Package Contents
MINING INDUSTRIAL
10m 10m
20m 20m
OR
For more information, please scan the barcode or visit beamcommunications.com/cellular
030179 R01
1. To complete installation, refer to the Beam LTE720 Panel Antenna Installation Guide.
2. Connect and tighten the N-Type connector of the cable to the bottom of the antenna. When installing each antenna cable:
• Tighten N-Type connector to each antenna cable with a xed or shifting spanner (18-20mm)
• Route and restrain the cable to prevent it from vibrating or moving under normal conditions, this could result in
damage to the cable or its connectors
• Protect the cable from chang or abrasions if the cable is in contact with a structure
• If a cable needs to be bent, avoid kinking it and ensure that each bend radius follows the bend radius limit of 25.4mm
• Use coaxial sealant, shrink-wrap tubing, electrical tape, or another suitable product to seal all cable connections
appropriately to prevent moisture and corrosion damage from weather exposure
• Use insulation material to prevent rain or moisture from going into the building along with the LTE cable
3. Selecting a location to install the MG200 LTE Gateway
• Locate a cool, dry, well-ventilated area away from any heat sources
• Check the LED lights and connectors on the LTE Gateway are accessible to users
• Ensure adequate clearance for cabling and Wi-Fi antennas
4. To install the MG200 LTE Gateway, refer to the MG200 LTE Gateway Quick Start Guide section 1-4.
WARNING!
The MG200 DC Power Source GND (and the grounding point) SHALL have the same voltage potential as the antenna. During
operation, the PWR should be always DC 9-36V higher than the GND.
5. Connect the SMA connector of LTE cable to the CELL MAIN and CELL AUX ports of the MG200 LTE Gateway.
WARNING!
Recommended: A Lightning Arrestor is tted on MG200 side.
6. To complete the installation and conguration refer to the MG200 LTE Gateway Quick Start Guide section 5 and onwards.
/
