Beam MG200-VAB Installation guide

  • Hello! I am an AI chatbot trained to assist you with the Beam MG200-VAB Installation guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
Installation Guide for Beam LTE Vehicular RV Bundle (MG200-VAB)
Face to
Satellite
Installation Guide for Beam LTE Vehicular RV Bundle
(MG200-VAB)
Applications
4WD CARAVAN
For more information please visit: beamcommunications.com/cellular
Optimal Antenna Installation Location
Install on the windshields or dash
Install with “Face to Satellite” logo facing the sky
Antenna must be installed with a separation distance
of at least 20cm away from all persons
Keep away from other antennas
Keep away from heat or fumes
Beam LTE716 Patch Antenna
Beam MG200
LTE Gateway
1x Alcohol Wipe
1 x Double Adhesive Pad 1 x Installation Guide
1 x Beam MG200 LTE Gateway Kit
1 x Beam LTE716 Patch Antenna
with 5m Cables
Package Contents
TRUCKS BUS/COACH RAIL
For more information, please scan the barcode or visit beamcommunications.com/cellular
030182 R01
1. Antenna Installation
DASH APPLICATION: Apply the Double Adhesive Pad to the BOTTOM side of the antenna
WINDSCREEN APPLICATION: Apply the Double Adhesive Pad to the TOP side of the antenna
Clean the mounting surface with the supplied Alcohol Wipe
Apply the Antenna with Double Adhesive to the mounting surface and apply pressure for 30 seconds to ensure good adhesion
2. Cable Installation
Keep away from heat and turning parts
Use cable ties to anchor the cables
3. Selecting a location to install the MG200 LTE Gateway
Locate a cool, dry, well-ventilated area away from any heat sources
Check the LED light and connectors on the LTE Gateway are visible and accessible
Ensure adequate clearance for the cabling
4. To install the MG200 LTE Gateway, refer to the MG200 LTE Gateway Quick Start Guide section 1-4. For power
connection, make use of the fused DC power cable supplied in the Beam MG200 LTE Gateway Kit.
5. Connecting Antenna cables to the MG200 LTE Gateway;
Connect the RED CABLES to the CELL MAIN and CELL AUX ports.
Connect the BLUE CABLE to the GPS port.
Connect the WHITE CABLES to the Wi-Fi ports.
6. To complete the installation and conguration refer to the MG200 LTE Gateway Quick Start Guide section 5 and onwards.
BOTTOM
TOP
/