4-Pin
6-Pin
Plug your Aegis
drive or other
FireWire peripheral
into the powered
6-pin FireWire port
AFW6-4 Quick Start Guide
The Apricorn AFW6-4 FireWire Adapter kit enables you to connect and power
your Aegis FireWire drive (6pin) or any other 6-pin FireWire peripheral to an
unpowered 4 pin FireWire or iLink port.
INSTRUCTIONS (see diagram below)
1. Plug the FireWire 6pin - 4pin Adapter into the 4-pin port on your computer.
2. Insert the included AC Adapter into the FireWire Adapter as shown below.
3. Plug the AC Adapter into the power socket - the 6-pin port is now powered.
4. Your AFW6-4 FireWire Adapter is now ready to power your drive. Plug your
Aegis drive or other FireWire peripheral into the powered 6-pin FireWire port.
Please note that when the
AFW6-4 FireWire Adapter kit is
plugged into a power source,
the 6-pin FireWire port on the
kit is live.
Therefore any device left
attached to the 6 pin connector
will be receiving power as long
as it is plugged in, even if the
4-pin data port is not plugged
into the computer.
Note:
Package includes:
FireWire 6 pin - 4 pin Adapter
AC Adapter
1
2
3
4
/
