AA612864
Copyright © 2015 King Slide. All Rights Reserved
R
TBD
1
2
2
1
2
1
2
1
2
3.Fix the outer member/bracket assembly to the frame. 4.Insert the unit to complete the installation
1) Take out the inner member and slide the intermediate member back. 2) Install the inner member onto the chassis.
2
2
1
Front bracket
Rear Bracket
Removing bracket
1
PUSH
Click!
Click!
Click!
Locking!
M4x4
1
Click!
Step 1.
Pull the middle member fully extended in lock
position, ensure ball bearing retainer is located
at the front of the middle member.
member
Step 2.
Insert chassis into middle-outer .
When hit a stop,pull / push release tab to
retract chassis into rack.
Step 3.
Tighten the thumbscrew onto rack
post to complete installation.
4
3
Note:
L,R side of rail are symmetrical.
Please repeat installation step for the other side.
Release
Release
Locking!
1.Press "PUSH" button.
2.Spin 180 degree to change the direction.
2
1
1
2
B
A
2
1
TBD
2X*A7
R
CAUTION!
Loop strap must be tied to the CMA crossbar. This is a
transportation accessory Remove the loop strap after the system
arrives at the final destination.
;
Copyright © 2015 King Slide. All Rights Reserved
E
F
C
A
B
D
2
1
Before installation, check the Cable Management
Arm (CMA) installation direction and switch the
CMA connector.
Cable Management Arm Installation
Cable Management Arm Release
1.Install the inner member
Install A onto B .
B
B
A
A
D
D
2.Install the outer member
Install C onto .D
D
D
C
C
3.Install the outer member
Install E onto F .
F
F
F
E
E
E
(1) Release the outer member
Press the "PUSH" button on the CMA plug-in part
todrawitout.
(2) Release the outer member
(A)Turn CMA 90 degree to the right hand side to
maintain the chassis or resume the removal.
(B)Press the "PUSH" button on the CMA plug-in
parttodrawitout.
(3) Release the inner member
Press the "PUSH" button on the CMA plug-in part
to draw it out.
A = CMA connector
B = CMA connector base on inner member
C = CMA connector
D=
E = CMA connector beside the center CMA body
F = CMA connector base on outer member
CMA connector base on outer member
PUSH
1U=2A
(X*=2A / 2B /2C/2D ; The drawings below are for assembling only. The real object should be considered as final.)
Basket size:
2U=2B
3U=2C
4U=2D
-
1
-
2
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Other documents
-
Fujitsu T5140 User manual
-
-
Oracle T5240 Installation guide
-
Supermicro SuperStorage Server 6048R-E1CR90L User manual
-
Dell DSS 7500 Owner's manual
-
Seagate Expansion Shelves & JBODs Installation and Maintenance Guide
-
-
Seagate CORVAULT Installation and Maintenance Guide
-
-