Printek Mt3 Series Mobile Thermal Printer Quick Setup Instructions

Type
Quick Setup Instructions
Important:
1. You must charge the battery for 24 hours prior to the first use.
2. Maximum battery capacity is reached after completing a minimum of (3)
normal usage charge and discharge cycles.
3. Always use Genuine Printek Paper to ensure optimal performance.
4. To load paper, pull on the Paper Door Handle to open the Paper Door.
Drop in paper roll as shown in diagram. Close Paper Door.
5. To load battery, slide Battery Door Releases down, and then open the
Battery Door. Insert the Battery as shown in diagram. Close the
Battery Door, and then slide the Battery Door Releases back to the
locked position.
6. To unload battery, slide the Battery Door Releases down, and open
the Battery Door only half way. At this point the battery can be removed.
7. To perform the self test, press and hold the PAPER FEED button, and
then press the ON button.
8. Note: For additional detailed information, please refer to the Operator’s
Manual. A copy of this manual can be downloaded by visiting
www.printek.com
BATTERY DOOR
ON/OFF BUTTON
PAPER FEED BUTTON
POWER ADAPTER INPUT
PAPER DOOR HANDLE
PAPER DOOR
SMART CARD READER
(OPTIONAL)
BATTERY
P/N 91244
P/N 91245 (5-pack)
P/N 91246 (20-pack)
BATTERY DOOR RELEASE
IrDA WINDOW
PAPER ROLL
P/N 91253 (5-pack)
P/N 91254 (35-pack)
P/N 91255 (Case of 200 rolls)
MAG CARD READER
(OPTIONAL)
POWER ON INDICATOR
(GREEN)
BATTERY CHARGING INDICATOR
(AMBER)
ERROR INDICATOR (RED) /
MCR READY INDICATOR (GREEN)
Printek Mt3/Mt3B Quick Setup Instructions
P/N #5688 Rev A
Printek Mt3/Mt3B Quick Setup Instructions cont.
Dip Switch Settings
Dip
Switch
Function Switch # Switch #
1Communication Interface SW1
RS232 Off
IrDA On
2 & 3 Baud Rate SW2 SW3
38,400 Off Off
19,200 Off On
9,600 On Off
2,400 On On
4 & 5 Parity bit SW4 SW5
No Parity Off Off
Odd Parity On Off
Even Parity On On
6Hardware Reset SW6
Enable Reset On
Disable Reset (default) Off
7Not Used SW7
8Printer Power Control SW8
Continuous Power On On
Auto Power Off Off
Please note:
Make certain the printer power is off before changing the dip
switch settings. New settings are only recognized during a
power up sequence.
SERIAL INTERFACE
Switch #1 is shown in the ON position for IrDA.
(Default setting for Mt3 from the factory)
Switch #3, and #4 are shown in the ON position for Bluetooth.
(Default setting for Mt3B from the factory)
Ph: (800) 368-4636
Fax: (269) 925-8539
Web: www.printek.com
Innovative Business Printing Solutions
RR
  • Page 1 1
  • Page 2 2

Printek Mt3 Series Mobile Thermal Printer Quick Setup Instructions

Type
Quick Setup Instructions

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI