2. V-ZUG
  3. 951

V-ZUG 951 Installation guide

  • Hello! I am an AI chatbot trained to assist you with the V-ZUG 951 Installation guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
  • Who should install the V-ZUG 951 warming drawer?
    What should be observed when fitting in flammable material?
    Where is the identification plate located?
    Who should carry out electrical connections?
    What type of mains isolating device should be provided?
    How should earthing be ensured?
    Where can information on the necessary mains voltage, type of current, and fuse protection be obtained?
    How should the drawer be secured?
    How should the mains cable be positioned after installation?
    What is the minimum depth required for installing the V-ZUG 951 warming drawer?
Installation instructions
Warming drawer 60-220
J951.113-0
18.2.09 ITH
1
These installation instructions apply to the model: 951
Identification plate
A Remove the drawer. The identification plate is located on the left-hand side next to the dial.
A Information on the necessary mains voltage, type of current and fuse protection is to be obtained from the identification plate.
1. Fix a bracket set 60 (not included in the scope of delivery) for an
appliance located above or below.
2. Place appliance in front of the niche and connect mains cable.
3. Carefully slide appliance into the niche until it is flush with the front
of the cabinets, ensuring that the mains cable is not pinched.
4. Open the drawer and fix in place from the front, using the 4 supplied
screws A.
The appliance should be installed by qualified personnel only. Each step must be carried out and checked in full in the order
specified.
Validity
General notes
If fitting in flammable material, the guidelines and standards for low voltage installations and for the fire protection must be strict-
ly observed.
Electrical connections
Electrical connections must be carried out by trained electricians in accordance with the guidelines and standards for low volt-
age installations and the specifications of the local electricity supply companies.
A plug-in appliance may only be connected to a socket outlet with earthing contact, installed according to specifications. A
mains isolating device with 3 mm contact opening should be provided in the house wiring system. Switches, plug and socket
devices, circuit breakers and fusible cut-outs which are accessible after installation and which have all-poles switching are per-
missible as isolating devices. Effective earthing and separately installed neutral and earth conductors ensure safe and fault-
free operation. After installation, live parts and cables with basic insulation must not be accessible. Old installations should al-
ways be checked.
Installation
The drawer must be secured by 4 screws to prevent tipping.
Ensuring that the mains cable is not pinched. After installation, the mains cable must not touch the back and the bottom of the
appliance.
A
Installation instructions
Warming drawer 60-220
J951.113-0
18.2.09 ITH
2
Built-in solo
Installing with oven
min. 550
220
560–568
596
547
218
600
378218
596
547
600
min. 550
560–568
594
374
X
567
Detail X
594
Niche
598
Appliance
/