Toro Floormat Kit, MyRide TimeCutter Riding Mower Installation guide

  • Hello! I've reviewed the installation instructions for the Toro MyRide TimeCutter 147-8764 floormat kit. This document outlines how to install the floormat using the provided plastic plugs, and details preparation steps for both gas and electric models. I'm ready to assist with any questions you might have about the installation process.
  • How many floormats are included in the kit?
    How many plastic plugs are included in the kit?
    What is the first step for preparing a gas model machine before installation?
    What is the first step for preparing an electric model machine before installation?
Form No. 3465-860 Rev A
Floormat Kit
MyRide
®
T imeCutter
®
Riding Mower
Model No. 147-8764
Installation Instructions
Installation
Loose Parts
Use the chart below to verify that all parts have been shipped.
Description
Qty .
Use
No parts required
Prepare the machine.
Floormat 1
Plastic plug 4
Install the oormat.
Preparing the Machine
Gas Models Only
1. Park the machine on a level surface.
2. Disengage the blade-control switch.
3. Move the motion-control levers outward to the
NEUTRAL -LOCK position.
4. Shut of f the engine and remove the key .
5. W ait for all moving parts to stop.
6. Allow machine components to cool.
Electric Models Only
1. Park the machine on a level surface.
2. Disengage the blade-control switch.
3. Move the motion-control levers outward to the
NEUTRAL position.
4. Engage the parking brake.
5. Shut of f the machine and remove the key .
6. W ait for all moving parts to stop.
7. Allow machine components to cool.
8. Remove the battery packs from the machine.
© 2023—The T oro® Company
81 1 1 L yndale A venue South
Bloomington, MN 55420 Register at www .T oro.com.
Original Instructions (EN)
Printed in the USA
All Rights Reserved
*3465-860*
Installing the Floormat
Secure the oormat to the platform using the 4 plastic plugs.
g469333
Figure 1
2
/