Rev-A-Shelf 51-35-211 Template

Type
Template

This manual is also suitable for

51 SERIES MONSTER/MAJESTIC SERIES FLOOR TEMPLATE
T-51-0816
Installation Template
12400 Earl Jones Way
Louisville, KY 40299
rev-a-shelf.com
Customer Service: 800-626-1126
Modelo de instrucción T-51-0816
Modèle pour l’Installation T-51-0816
ALIGN WITH CENTER
OF CABINET OPENING
ALIGN FRONT OF TEMPLATE WITH BACK OF CABINET DOOR
Place template into cabinet, ensuring that the center line of the template matches
the center of the cabinet. Position the front edge of the template where your
cabinet door stops when fully closed.
FOR OVERLAY DOORS: edge the template to the front of the cabinet opening.
FOR INSET DOORS: measure the thickness of the face frame and place template
that distance back from the cabinet opening.
CREATE HOLE LOCATIONS FOR SECURING FRAME
Using an awl or pencil, mark through the marked screw locations onto your
cabinet oor. Pre-drill these areas with the size drill bit specied.
INSTALLING TOGGLERS AND SECURING THE FRAME
Refer to the instruction booklet for installation of the provided toggler anchors.
Place assembled slide set over the top of the pre-drilled holes and toggler
anchors. Secure the frame at the two anchor locations rst with the provided (2)
1/4-20x2” Phillips Bolts. Then, secure the the rest of the pre-drilled holes with the
provided (10) #8x1” Deep Thread Flat Head Screws.
FRONT FRONT
DRILL 1/2” HOLE
FOR TOGGLER
ANCHOR
DRILL 1/2” HOLE
FOR TOGGLER
ANCHOR
DRILL 1/16” HOLE FOR WOOD SCREWS
DRILL 1/16” HOLE FOR WOOD SCREWS
T-51-0816
  • Page 1 1

Rev-A-Shelf 51-35-211 Template

Type
Template
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI