2. TBS
  3. MOI+

TBS MOI+ Operating instructions

  • Hello! I've reviewed the user manual for the MOI+ receiver. It outlines the steps to update the device's software using a USB flash drive. The guide details how to download the latest software, format the USB correctly, and initiate the update process, which is indicated by progress on the LCD screen. I'm ready to answer any questions you may have about this procedure or the device itself.
  • How to update MOI+?
    What should I do after the software update completes?
    Is it necessary to restart the device after the update?
How to Update MOI+?
1. Download the latest software (system, kernel) from:
http://www.tbsdtv.com/download/
2. Copy the software that you want to update to a USB flash drive (mini 1GB,Please
must use FAT16/32 format usb flash driver, do not use NTFS format usb flash
driver), for example, if you just need to update the kernel, then download only
the latest kernel and copy it to the USB flash drive root folder, if you copy all of
the three files: system, kernel to the USB flash drive, MOI+ will update all of them
and it will take a bit longer.
3. Make sure your MOI+ is powered off, connect the USB flash drive to it, and then
power on, the update will start, on the LCD screen it displays:
-"Welcome MOI+"-
-When update the kernel it shows the kernel loading progress in percentage (%)
-When update the system, it shows the system loading progress in percentage (%)
and "Reading, please later..."
4. After the update completes (takes about 5 minutes), the IP address will be
displayed on the LCD screen, make sure the network cable is connected.
NOTE: There is no need to restart MOI+ after the update.
To check the version, you can go to the web user interface by entering the IP address
displayed on the LCD screen to the address bard of the browser.
Any questions or problems please contact: moisupport@tbsdtv.com
Thank you.
/