Black Talon Seats 355300BK Owner's manual

Brand
Black Talon Seats
Model
355300BK
Type
Owner's manual

This manual is also suitable for

Black Talon Seats 355300BK are designed to provide a comfortable and adjustable seating experience. With multiple mounting holes and slots, these seats can be easily installed on various types of equipment.

The steel armrest mounting brackets can be rotated to a vertical position for normal operation, allowing the armrests to pivot between vertical and horizontal positions. A set screw in each armrest prevents it from pivoting beyond the desired positions.

Black Talon Seats 355300BK are designed to provide a comfortable and adjustable seating experience. With multiple mounting holes and slots, these seats can be easily installed on various types of equipment.

The steel armrest mounting brackets can be rotated to a vertical position for normal operation, allowing the armrests to pivot between vertical and horizontal positions. A set screw in each armrest prevents it from pivoting beyond the desired positions.

355 Series Seat Assembly and Operating Instructions.docx Page 1 of 2
7-20-17
Assembly and Operation Instructions
355 Series Seat
1. Seat Mounting
a. There are multiple holes and slots in the bottom side of the slide rails that can be
used for mounting the seat to the equipment – see Figure 1
2. Seat Operation
a. The seat typically comes with the steel arm rest mounting brackets folded down –
see Figure 2.
b. For normal operation, the arm rests mounting bracket are to be rotated to the
vertical position – see Figure 3.
i. To rotate the arm rest mounting brackets to the normal operating position:
1. Rotate the front of the bracket up until it is in a vertical position.
2. Once in the vertical position, slide the arm rest mounting bracket
down (it will slide down about 1”). The cutouts in the arm rest
bracket will keep the bracket from rotating forward while in the
normal operating position.
3. The arm rest itself will now pivot between vertical and horizontal
(forward).
c. In the back side of each arm rest there is a slot with a set screw inside of it – see
Figure 4. This set screw is what stops the arm rest from pivoting down beyond
the horizontal position (the normal operating position) and from pivoting up
beyond the vertical position. The set screw should be extending out of the steel
rod it is screwed into (extending towards the back of the arm rest) by about 1/2” –
5/8” (this is the normal operating position). If this set screw is screwed all the
way into the steel rod, the arm rest will not stop in the horizontal position, but will
continue to pivot downward.
d. To adjust the seat position front-to-back, move the lever, that is under the right
front corner of the seat, outwards. This will release the position catch and the
seat can be slid forwards and backwards. Releasing the lever will allow the lever
to catch a latching position to stop the seat from sliding forwards or backwards.
There is approximately 6” of slide travel available.
355 Series Seat Assembly and Operating Instructions.docx Page 2 of 2
7-20-17
Figure 1
Figure 2
Figure 3
Figure 4
  • Page 1 1
  • Page 2 2

Black Talon Seats 355300BK Owner's manual

Brand
Black Talon Seats
Model
355300BK
Type
Owner's manual
This manual is also suitable for

Black Talon Seats 355300BK are designed to provide a comfortable and adjustable seating experience. With multiple mounting holes and slots, these seats can be easily installed on various types of equipment.

The steel armrest mounting brackets can be rotated to a vertical position for normal operation, allowing the armrests to pivot between vertical and horizontal positions. A set screw in each armrest prevents it from pivoting beyond the desired positions.

Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Other documents