2. Thermo King
  3. TriPac 3 Nameplate Placement

Thermo King TriPac 3 Nameplate Placement Installation guide

  • I have reviewed the provided Installation Instructions document for the TriPac 3 Stainless Steel Condenser nameplate. This document outlines the necessary steps for proper nameplate installation, including removing protective films and applying the nameplate to the lower right-hand corner of the condenser housing. I am ready to assist with any questions you have about these instructions or the product.
  • What is the first step in installing the nameplate?
    Where should the nameplate be installed?
    What should you do after positioning the nameplate?
TJ 57307-19-IS Rev. A ©2023 Trane Technologies 1
1. Remove the protective film from stainless steel condenser housing.
2. Clean the lower right-hand corner where nameplate will be installed.
3. Remove protective film from nameplate and position onto housing in location shown.
4. Apply pressure evenly across the surface of the nameplate.
1.00 in.
(25.4 mm)
1.00 in.
(25.4 mm)
RCS2250
Installation Instructions
TriPac®3 Nameplate Placement — Stainless
Steel Condenser
2©2023 Trane Technologies TJ 57307-19-IS Rev. A
Customer Satisfaction Survey
Let your voice be heard!
Your feedback will help improve our manuals. The survey is accessible through any internet-
connected device with a web browser.
Scan the Quick Response (QR) code or click Technical Publications TK Americas Feedback to
complete the survey.
/