Extron MTP T SV A, & MTP T SV A RCA User manual

Category
Receiver
Type
User manual
IMPORTANT:
Go to www.extron.com for the complete
user guide, installation instructions, and
specifications before connecting the
product to the power source.
MTP AV Series • Setup Guide
This guide provides basic instructions for an experienced installer to set up and operate any of the Extron
Mono
Stereo
Jumpered for
Mono (Default)
MTP AV transmission systems.
Pre-installation — Jumpers
The units are factory-set so that one unit cannot remotely power another and to handle mono audio.
They can be set to handle stereo audio and provide remote power. A stereo audio unit is only
compatible with older generation units.
The appearance and location of the jumper block change with each unit. See the illustration above or
see the MTP AV Series User Guide at www.extron.com to set the jumpers for the units to be installed.
Installation
Step 1 — Mounting
Turn off or disconnect all equipment power sources and mount the MTP transmitter and receiver as required.
Step 2 — Transmitter Inputs
INPUT
LR
S-VIDEO
INPUT
VIDEO
LR
NOTE: The illustration on the right shows the available connections. Your unit may look different.
z Plug a video source into the applicable input connector:
z S-video input connector — A 4-pin mini DIN (Y/C) connector
z Composite video input connector — A female BNC connector
z Plug an audio source into the applicable audio input
LR
LR
Unbalanced Stereo Input
Balanced Stereo Input
(high impedance)
(high impedance)
Ring
Sleeve (s)
Tip
Sleeve
Tip
Sleeve
Tip
Tip
Ring
Do not tin the wires!
connector:
z 5-pole captive screw connector — Wire the connector
as shown on the right.
z Two RCA connectors
Step 3 — TP Cables Between Units
ATTENTION: Damage to the unit may occur if TP cables
are mis-wired as crossover cables.
Terminate a TP cable as shown in the gure to the right.
Connect it between the output port of the transmitter and
the input port of the receiver.
Step 4 — Receiver Outputs
z Plug a video display into the applicable output connector:
z S-video output connector — A 4-pin mini DIN (Y/C)
connector
z Composite video output connector — A female
BNC connector
z Plug an audio device into the applicable audio output
connector:
z 5-pole captive screw connector — Wire the connector as shown below.
z Two RCA connectors
ATTENTION: Connect the sleeves to ground ( ). Connecting the sleeve to a negative (-) terminal will damage the audio
output circuits.
1
MONO AUDIO
2
1
MONO AUDIO
2
Unbalanced Output
Balanced Output
Do not tin the wires!
Mono output 1-
Sleeve(s)
Mono output 1+
Mono output 2+
Mono output 2-
Sleeve(s)
Mono output 1
Mono output 2
NO GROUND.
NO GROUND.
Pin T568A
Wire Color
T568B
Wire Color
MTP Signal
Composite / S-video
1 White-green White-orange Reserved / Chroma+
2 Green Orange Reserved / Chroma-
3 White-orange White-green Mono Audio+
4 Blue Blue Video+ / Luma+
5 White-blue White-blue Video- / Luma-
6 Orange Green Mono audio-
7 White-brown White-brown Reserved
8 Brown Brown Reserved
NOTES:
If you are using Enhanced Skew-Free™ AV cable, use the
TIA/EIA T568A standard only.
The pin assignment is different if you have shifted the jumpers in
“Pre-installation — Jumpers” above (see the MTP AV Series User
Guide).
12345678
RJ-45
Connector
Insert Twisted
Pair Wires
Pins:
68-732-50 Rev. E
01 13
Extron Headquarters
+800.633.9876 Inside USA/Canada Only
Extron USA - West Extron USA - East
+1.714.491.1500 +1.919.850.1000
+1.714.491.1517 FAX +1.919.850.1001 FAX
Extron Europe
+800.3987.6673
Inside Europe Only
+31.33.453.4040
+31.33.453.4050 FAX
Extron Asia
+800.7339.8766
Inside Asia Only
+65.6383.4400
+65.6383.4664 FAX
Extron Japan
+81.3.3511.7655
+81.3.3511.7656 FAX
Extron China
+4000.EXTRON
+4000.398766
Inside China Only
+86.21.3760.1568
+86.21.3760.1566
FAX
Extron Middle East
+971.4.299.1800
+971.4.299.1880 FAX
Extron Korea
+82.2.3444.1571
+82.2.3444.1575 FAX
Extron India
1800.3070.3777
Inside India Only
+91-80-3055.3777
+91 80 3055 3737
FAX
© 2013 Extron Electronics All rights reserved. www.extron.com
MTP AV Series • Setup Guide
Step 5 — Power
Power Supply
Output Cord
SECTION A–A
Ridges
Smooth
AA
POWER
12V
xA MAX
Tie
Wrap
Rear
Panel
Ridges
Earth
Ground
3/16"
(5 mm)
Max.
Wire the 2-pole captive screw connectors for the included external 12 VDC power
supplies as shown on the right. Plug one power supply into the transmitter and the
other into the receiver.
Grounding the power input port
Extron MTP AV products can be adversely affected by electrostatic discharge (ESD)
if they are not grounded correctly.
To prevent malfunctions or product damage, an experienced installer can correctly
ground an Extron MTP AV product by inserting one end of the grounding wire to the
negative or ground pin on the power input connector (see the image on the right). Tie
the other end of the wire to an earth ground.
If you have any questions about how to ground a product in a specic application, contact an Extron technical support specialist.
Step 6 — Receiver Sharpness and Gain
z Sharpness — Adjusts the output image sharpness for long cable runs.
z Gain control — Adjusts the brightness of the output image to compensate for long cable runs.
z S-video receivers — There are separate controls for luminance (Y) and chrominance (C).
SHARP
C GAIN
Y GAIN
SHARP
GAIN
S-video Receiver
Composite Video
If the setting is too low, the image may appear in monochrome. Adjust the
chrominance (C gain) until color appears.
z Composite video receivers — There is only one gain control on composite video MTP
receivers.
NOTE: The control knobs shown above on the right are removable to limit access if desired.
INPUT
MTP T SV A RCA
VIDEO OUTPUT
L
R
12V
0.5a
MAX
OUTPUT
SHARP
L R
INPUT
VIDEO
12V
0.5a MAX
MTP R SV A
XPA 1002
1 2
LIMITER/PROTECT
SIGNAL
OVER
TEMP
MTP T SV A RCA
Twisted Pair
Transmitter
MTP R SV A
Twisted Pair
Receiver
TP Cable
(up to 1,000')
DVD Player
Flat Panel
Display
Extron
SI 28
Surface-
mount
Speakers
Extron
XPA 1002
Audio Power
Amplier
Figure 1. Example of a Typical MTP AV Application
  • Page 1 1
  • Page 2 2

Extron MTP T SV A, & MTP T SV A RCA User manual

Category
Receiver
Type
User manual

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI