TM
DRAFT BEER SYSTEM
USER MANUAL
PLEASE READ WARNINGS AND INSTRUCTIONS THOROUGHLY
BEFORE USING THE TAPOLOGY!™ FOR THE FIRST TIME.
WARNINGS:
PLEASE NOTE: TAPOLOGY!™ WORKS WITH 12 OZ. CANS.
*THERE ARE A FEW UNIQUE SHAPES OF 12 OZ. CANS THAT MAY NOT FIT.
ALSO NOTE: UNIT SHOULD BE RUN WITH 12 OZ. OF WARM WATER
WITH MILD DISH DETERGENT TO RINSE TUBING BEFORE FIRST USE
.
SPECS:
1. The Tapology!™ is intended for household use only. Commercial
use may cause damage to the unit.
2. Do NOT use the Tapology!™ if the unit shows any visible damage or
has fallen.
3. Do NOT immerse the Tapology!™ in water or any other liquid.
4. Do NOT use near a sink or any vessel that contains water.
5. Do NOT place the Tapology!™ on or near a hot surface.
6. Always place the Tapology!™ on a horizontal, stable, and
dry surface.
7. After using the Tapology!™, clean the unit with a damp cloth then
store in a cool, dry place out of reach of children.
8. This appliance should not be used by children.
9. Before storing, run some water through the unit to clean the inner
tubing to keep your Tapology!™ from building up residue and odors.
10. Keep batteries out of reach of children.
11. Do not mix old and new batteries.
12. Do not expose batteries to extreme heat.
13. Please recycle old batteries. Do not dispose with other
household waste.
Power Source: 1.5V, 2 AA alkaline batteries (NOT INCLUDED)
Operation: Ultrasonic vibration
Material: ABS, silicone tube
PARTS LIST:
1. Tap Handle
2. Pump Assembly
3. Main Body
4. Pedestal
5. Base
1
2
3
4
5
INSTRUCTIONS:
1. Turn the Pump Assembly counterclockwise from the Main Body
and lift up.
2. Open the battery cover by twisting the screw counterclockwise.
Place two AA batteries into the compartment as shown. Replace
the battery cover and screw down tight.
3. To open the Tapology!™, hold the Base and twist the Main Body
counterclockwise and pull up.
4. The Tapology!™ only supports 12 oz. cans of beer. Line up the
350ml marking on the pedestal with the notch located on inside
of base for 12 oz. cans. The 330ml marking only applies to some
import beverages and does not work with standard American
beverage can sizes.
5. Open your beverage and place onto the Pedestal. Make sure the
opening of the can faces towards the front of the Base. Feed the
silicone tube into the opening in the can and then slide the Main
Body over the beverage and onto the Base.
Once you have it on the Base, match the line on the Main Body to
the dot on the Base and turn clockwise until both lines are aligned
and parts are securely attached.
6. Either hold your cup or place on the grill of the Base and pull
the Tap Handle towards you to start the flow. It is best to use a
pilsner, pint glass, or Arctica™ Party Cup with the Tapology!™.
When the cup is mostly full, you can push back on the Tap Handle to
create the amount of foam that you desire on your beer.
NOTE: It is normal for the unit to sputter when you are out of beer.
CLEANING AND MAINTENANCE:
• Rinse out empty beer can. Fill with hot water
and follow steps 3-5 to run water through unit to
clean. Remove can when complete. If needed,
mild dish detergent can be used. Unit should be
flushed with clean water afterwards.
• Wash the base with water if needed.
• Remove batteries when not in use.
• The Pump Assembly contains electronics and
should not be submerged in water. Wipe clean
with damp cloth.
• If internal hoses become loose inside the main
body and spout follow the steps listed below.
1. Feed the small tube with tube connector into
the spout and twist while applying pressure.
2. Attach longer tube to tube connector and feed
back through hole into the Main Body.
3. Gently push tube connector into place to secure.
TM
DRAFT BEER SYSTEM
For customer service call 888.784.2835 (+1.423.402.9010 for outside the United States) or visit us online at viatekproducts.com
Pour le service a la clientele appelez le 888.784.2835 (+1.423.402.9010 a l’extérieur des États-Unis) ou visitez viatekproducts.com
Para servicio al consumidor llame al 888.784.2835 (fuera de Estados Unidos marque +1.423.402.9010) o visite viatekproducts.com
MADE IN
CHINA
Read Instructions
Before Operating
PATENT
PENDING
DO NOT DISPOSE OF BATTERIES IN FIRE. ALWAYS DISPOSE OF BATTERIES PER LOCAL & FEDERAL GUIDELINES.
© 2017 VIATEK CONSUMER PRODUCTS GROUP, INC. All specications are subject to change without notice. All rights reserved.
Viatek Consumer Products Group, Inc. 6011 Century Oaks Dr. Chattanooga, TN 37416
Rev:
Model:
080317
TAP01
/
