Page is loading ...
The Bladeless Tabletop Fan can be powered either by
battery or USB connection.
1. To use USB power, simply plug the included cord into the
side of the fan (see Fig. 1). You may plug the USB end of
the cord into a desktop computer, laptop, or any other USB
outlet to power the fan.
2. To install batteries, slide the panel at the bottom of the fan in
the direction indicated by the arrow on the panel (see Fig. 2).
Install 4 AAA batteries and replace the panel.
Tabletop Bladeless Fan Instructions
Fig. 1 Fig. 2
Fig. 3 Fig. 4 Fig. 5
The adjustable angle back on the Tabletop Fan can be used
to direct the breeze.
1. Extend the easel from the back of the fan (see Fig. 4).
2. Lean the fan back to rest on the easel (See Fig. 5).
Read instructions
Before Operating
MADE IN
CHINA
© 2012 VIATEK CONSUMER PRODUCTS GROUP, INC. All specifications and prices are subject to change without notice. All rights reserved.
Viatek No Question Protection - Protect your product with Viatek Warranty Services.
Product is replaced or reimbursed 100%. Protection for 1-year beyond our standard
warranty, No shipping charges, no deductible, Your product is protected from any
mechanical or electrical failures caused by power surges or manufacturer’s defects.
Order online at viatekproducts.com today.
For Canada customer service call 423.402.9010 or visit us online at viatekproducts.com
For customer service call 888.7.VIATEK or visit us online at viatekproducts.com
Pour le service a la clientele appelez le 888.7.VIATEK ou visitez viatekproducts.com
Para servicio al consumidor llame al 888.7.VIATEK o visite viatekproducts.com
PATENT PENDING
REV-
Model No.
BFT01 02/25/13
The cooling sponge can be used to activate the Tabletop
Bladeless Fan’s Cool Breeze feature.
1. To access the sponge, slide off the back panel by pushing it
down (see Fig. 6).
2. Remove the cooling sponge and dampen with water.
The sponge should not be wet to the point of dripping. If
necessary, gently press the excess moisture from the sponge
before freezing. Lay sponge at in freezer so that it freezes in a
shape that ts in the fan properly. Once the sponge is frozen,
place it in the back of the fan (see Fig. 7).
You may also apply fragrance to the cooling sponge to act as an air freshener, but
it is recommended that a modest amount of fragrance is used the rst time so that
you can better gage how strong you would like the scent in the future.
3. Replace the back panel, starting from the position in Fig. 8 and
pushing up. The Cool Breeze feature is now activated, making
your Tabletop Bladeless Fan’s breeze extra cool.
It is recommended that the sponge be allowed to dry completely while installed in
the back of the fan so that it retains its shape.
Fig. 6 Fig. 7 Fig. 8
/
