2. Q-BEAM
  3. Q-BEAM Brightsmith Max 14 LED Aluminum Flashlight
Q-BEAM Brightsmith Max 14 LED Aluminum Flashlight

Q-BEAM Q-BEAM Brightsmith Max 14 LED Aluminum Flashlight User manual

  • Hello! I've reviewed the user manual for the Q-Beam Brightsmith Max 809-2731-1 Flashlight. This flashlight features 14 LEDs, 3 light modes, and is powered by 3 AAA batteries. I'm ready to answer any questions you have about its operation or specifications as detailed in the manual.
  • How do I install the batteries?
    What type of batteries should I use?
    How do I change the light modes?
Q-Beam™
Brightsmith Max
14 LED Aluminum Flashlight w/ Lanyard
READ MANUAL FULLY BEFORE USING ™
BEFORE FIRST USE: Open and remove battery
sticker to allow batteries to operate.
BATTERY REPLACEMENT: Install batteries
by rst unscrewing tail cap. Remove battery
compartment. Insert 3 AAA batteries into
battery compartment; two with positive (+) ends
toward head of lfashlight, one with negative
(-) end toward head of
ashligt (Fig. 1). Re-insert
battery compartment into
ashlight with positive (+)
end toward ashlight head.
Make sure spring is in
place in tail cap. Replace
tail cap by screwing in securely. Use alkaline
batteries for maxiumu brightness and life.
NOTE: Do not mix old and new batteries.
Do not mix
alkaline, standard
(carbon - zinc),
or rechargeable
(nickely cadmium)
batteries.
PUSH BUTTON SWITCH: Simply push button
switch to activate lighting modes: High, Low,
Strobe, O.
BULB REPLACEMENT: LEDs (Light Emitting
Diodes) never need replacement.
Figure 1
888.784.2835 (+1.423.402.9010) [email protected]
Customer Service / Le service a la clientele / Servicio al Consumidor
MADE IN
CHINA
Read Instructions
Before Operating PATENT
PENDING
DO NOT DISPOSE OF BATTERIES IN FIRE. ALWAYS DISPOSE OF BATTERIES PER LOCAL & FEDERAL GUIDELINES.
© 2021 VIATEK CONSUMER PRODUCTS GROUP, INC. All specications are subject to change without notice. All rights reserved.
Viatek Consumer Products Group, Inc. 6011 Century Oaks Dr. Chattanooga, TN 37416
Rev:
Viatek® warrants this product to be free of manufacturing defects. Should any such defect develop or become evident within one year from
the date of purchase, Viatek® will replace the entire product or, at its option, repair or replace the defective part(s) without charge.
Contact Viatek® customer service at 888.784.2835 or at [email protected] to determine whether it is necessary to return the unit. To return,
securely pack the entire unit. Be sure carton clearly identies sender by name and address. Attach a letter or card describing defect and
original sales receipt. Mail prepaid to Viatek Consumer Products Group, Inc. 6011 Century Oaks Dr. Chattanooga, TN 37416.
This warranty is void if damage or malfunction is due to abuse or failure to operate product in accordance with instructions and on
recommended electrical current. This warranty gives you specic legal rights and you may also have other rights which vary from state to
state. If you have any questions, or would like to learn more about Viatek®, please contact us at 888.784.2835 or at [email protected].
Register your product online at viatekproducts.com/register-your-product-warranty/
Model:
VIATEKPRODUCTS.COM
For questions, assistance, or replacement parts, do not return to your retailer. Contact Viatek® customer service below.
For refunds on items not purchased from Viatek® directly, please contact your retailer.
VIATEK® 1-YEAR LIMITED WARRANTY
030922
809-2731-1
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation.
Warnings:
• Use only as directed
• To prevent damage to eyesight, never look into light when light is on.
• DO NOT submerge light in water. Water resistant in normal rain.
• DO NOT allow children to handle or operate.
• DO NOT use this product for other than its intended use.
• DO NOT install or operate in close proximity of combustible or ammable
materials.
• DO NOT install in gas tight enclosures.
• DO NOT attempt to charge or operate this light if cord, plug, battery, bulb, or
any part of light is damaged or corroded.
WARNINGS & CARE INSTRUCTIONS
Product Specifications
• 14 White LEDs
• 3 Light Modes: High, Low,
& Strobe
• 3 AAA alkaline batteries,
included
• Lumens – 78
• Beam – 35 meters
• Run Time – 4 hours
/