MODEL NO: H-92-YW
Instruction Manual
LOCATION OF CONTROLS:
Specifications
1. Light Head
2. 6 SMD (3 Warm White & 3 White) LEDs
3. ON/Selectable Dimmer/OFF Switch
4. Flexible Metal Neck
6. Micro USB Port
7. LED Indicator
8. Magnets*
9. Built-In Rechargeable Battery
10. Micro USB Cable
*underneath unit
Operation
* 1st press to turn ON both warm white and white light.
* 2nd press to turn ON warm white light only.
* 3rd press to turn ON white light only.
* 4th press to turn the light OFF.
**When light is ON, hold button to change the brightness level of each color.
Built-In Lithium polymer rechargeable battery
* The light is powered by 3.7V 900mah internal Lithium polymer rechargeable battery.
* If LEDs appear to be dim, this is an indication that you may need to recharge the battery.
* Full charging time is approximately 3-3.5 hours.
* You can use your computer to power the clip light. Plug one end of the USB cable (included) into the direct
power port on the back of light base. Plug the other end into any USB port on your computer or other device
with 1A output. The power indicator light will illuminate red when the USB cord is plugged in. The red led
indicator will auto off once the battery is fully charged.
**Please do not try to remove/replace internal Lithium polymer
rechargeable battery as it is danger.
Clip
Magnet Base
Allow you to mount the clip light to any flat metal surface.
H-92-YW
Color Temperature: 3000K Warm White and 8000K Cool White
30000 Hours
Voltage and Battery of Light: 3.7V 900 mah Rechargeable Battery
RECHARGEABLE LED CLIP/BOOK LIGHT
5. Clip/Base
The clip will allow you to clip the light almost anywhere you need it.