15
Introduction
General notes
The P-06B is provided with the waterproof
performance, however, do not have water
entered into the inside of the unit, or do
not spray water over accessories and
optional items.
The FOMA terminal is waterproof (to the extent
specifi ed by the IPX5 and IPX7 classes) once the
connector terminal cover and inner cover have been
closed tightly and the back cover has been attached.
However, this does not mean that the FOMA terminal
is absolutely waterproof.
Do not attach/remove the battery pack, nor open/close
the connector terminal cover or back cover while you
are in the rain or with drops of rain remained on your
FOMA terminal. Otherwise the water entered into the
inside of your FOMA terminal might cause corrosion
of internal parts. Note that accessories and optional
items are not provided with waterproof performance.
If the trouble with your FOMA terminal is found to be
resulted from such exposure to water, the guarantee
is not supported. In that case your troubled FOMA
terminal is to be repaired fees charged.
Use a dry soft cloth such as the one for
cleaning glasses to clean the equipment.
The display may be scratched if it is rubbed hard
with a dry cloth.
Stains may result from droplets of water or dirt if
they are left on the display.
Do not use alcohol, thinner, benzene, detergent or
other solvents for cleaning, otherwise the printing
may be removed or discoloration may result.
Occasionally clean the terminals of the
equipment using a dry cotton swab, etc.
The soiled terminals deteriorate the connection
and might cause power discontinuity or incomplete
charging. Wipe the terminals with a cotton swab, etc.
Take care not to damage the terminals when
cleaning them.
Do not place the FOMA terminal near an air
conditioner outlets.
Condensation may form due to rapid changes in
temperature, and this may corrode internal parts
and cause malfunction.
Do not apply excessive force onto the
FOMA terminal and battery pack.
If you put the FOMA terminal in a bag along
with many other articles or sit with the FOMA
terminal in a clothes pocket, the display, internal
circuitry and the battery pack could be damaged
or malfunction. Also, if an external device is left
connected to the connector terminal (earphone/
microphone terminal), the connector could be
damaged, or malfunction.
Carefully read each instruction manual
attached to the FOMA terminal or adapter.
Do not rub or scratch the display part with
metals.
Doing so might cause damage to the part,
resulting in trouble or malfunction.
Notes on handling the FOMA terminal
Never forcibly press the surface of the touch
panel, or operate it with something having a
sharp point like a claw, ballpoint pen, or pin.
Damage to the touch panel might result.
Avoid using in extremely high or low
temperatures.
The FOMA terminal should be used within a
temperature range of 5°C to 40°C (however,
the use at 36°C or higher should be limited to
temporal use in a bathroom etc.) and a humidity
range of 45% to 85%.
If the FOMA terminal is operated near a
landline phone, television set, radio or
other devices in use, it may adversely affect
the devices. Operate the FOMA terminal as
far away from these devices as possible.
It is recommended that you make separate
notes of the information stored in the
FOMA terminal and keep such notes in a
safe place.
We take no responsibility for any loss of the stored
data items.
Do not drop the FOMA terminal or subject
it to strong impacts.
Malfunction or damage may result.
Do not insert an external device to the
connector terminal (earphone/microphone
terminal) at a slant when connecting, and
do not pull it out when it is inserted.
Malfunction or damage may result.
Make sure that no objects such as the touch
pen or strap will get caught between the parts
of the FOMA terminal when you close it.
Malfunction or damage may result.
The FOMA terminal becomes warm
during use or charging but this is not an
abnormality. Use the FOMA terminal as it is.
Do not leave the camera in places exposed
to direct sunlight.
Pixels may be discolored or burns may result.
When using the FOMA terminal, ensure
that you shut the lid for the connector
terminal.
Dust or water might enter into the FOMA terminal,
causing malfunction.
Do not use the FOMA terminal with the
back cover left removed.
The battery pack might come out, or malfunction
or damage may result.
Do not apply an excessively thick sticker
onto the surfaces of the display, keys, or
buttons.
Malfunctioning, damage or problems with
operation may result.
Handling Precautions